Hello,
Sorry for the delay, our tools expert informed us that in this situation, the room temperature discharge is getting too close to the OCV curve, which is causing this negative resistance to be seen.
If possible, please try using a 1C rate discharge…
Hello Kelvin,
Whenever you did the GPCRB tool, was the test done at 0C or -10C. The change I made will apply for all temperatures. However, the GPCRB tool optimizes the parameters for the certain temperature that the gauge will be used for.
Regards.
…
Part Number: BQ40Z50-R2 Other Parts Discussed in Thread: GPCRB I looked at some old posts that suggested the GPCRB tool be used if the BQ40Z50-R2 is operating over a large temperature range. Our pack is being discharged over a temperature range of -20C…
Part Number: BQ34Z100-G1 Other Parts Discussed in Thread: GPCRB Hi
I have a query need your help.
GPCRB report feedback: Ra0_ch, mOhm : 119 This firmware is not explicitly supporting Ra0_ch, FCC drop could occur at low
Attached the log data and GPCRB report…
Part Number: BQ4050 Other Parts Discussed in Thread: GPCRB , BQ34Z100-G1 Hi
I have a query need your help.
GPCRB report feedback: Ra0_ch, mOhm : 119 This firmware is not explicitly supporting Ra0_ch, FCC drop could occur at low
Attached the log data and…
Part Number: BQ40Z50-R2 Other Parts Discussed in Thread: GPCRB , BQSTUDIO Hello，
1. Is GPCRB before or after learning?
2. Is battery pack or battery cell recommended for GPCRB?
3. In my opinion, the data is to configure the chip first, and then export gg…
Part Number: BQ27Z561-R2 Other Parts Discussed in Thread: GPCRB
Hi team,
1. According to the guidance on the official website, I need to collect VIT data before doing GPCRB. is there any requirement for the srec file to be used at this time? Was it before…
Part Number: BQ40Z50-R2 Other Parts Discussed in Thread: GPCRB Dear Sir
Recently, our company has a new project to do low-temperature ID optimization, and we found that the GPCRB link cannot be accessed. Do you know what the situation is? When can it…
Part Number: BQ34Z100-G1 Hello,
I receive the report but in the report I don't have the chem file. In the file GPC_report, I have
Resistance temperature compensation optimizer, rev=3.48
Optimized Impedance Track parameters:
Qmax, mAh…
