Part Number: HALL-TRIGGER-EVM Other Parts Discussed in Thread: DRV5032 Tool/software: Hi, Could you please suggest an alternate with Lower cost with same Pin & similar Package for below MPN: AH180N-WG-7 (Hall Effect Switch). Maximum output voltage…
Part Number: LDC-HALL-HMI-EVM Other Parts Discussed in Thread: TMAG5273 , TMAG5273EVM Tool/software: Hi, We have a LDC-HALL-HMI-EVM, but we would like to be able to read the axes of the TMAG5273 chip on the board like the TMAG5273EVM_GUI. Is there a possibility…
Part Number: DRV8350H-EVM Tool/software: Hello.
I am John. I am designing a BLDC motor drive with DRV8350H.
I am writing this because I have a question about the circuit design.
My product receives PWM speed command from an external MCU and operates a…
Part Number: DRV8350H-EVM Tool/software: Hello.
I am John. I am designing a BLDC motor drive with DRV8350H.
I am writing this because I have a question about the circuit design.
My product receives PWM speed command from an external MCU and operates a…
Hello Jacques,
Glad the EVM is working for you now. Thanks for your feedback on it working on the desktop but not on the cloud GUI. We will make sure to look into that a bit more.
Let us know if you have any other issues.
Best Regards,
Justin Beigel
Hi Shlomi,
Just in case, Can you check that the hall connections to the EVM and the jumpers on the EVM are similar to the image below? The configuration shown below is for digital hall sensors.
Also, while spinning the motor by hand, can you provide…
Part Number: DRV8350H-EVM Other Parts Discussed in Thread: DRV8350 , DRV5021 , MSP430F5529 I have referenced the DRV8350 EVM and have a new design , now it indicated my HALL SENSOR error. I have used the oscilloscope and measured the Connection end of Hall…
Part Number: DRV8300DPW-Q1EVM Other Parts Discussed in Thread: LAUNCHXL-F28379D , , UA78M Tool/software: Hi,
I wish to powerup LaunchXL-f28379d using the DRV8300DPW-Q1EVM EVM.
While doing so, I've noticed a high temperature issue of the UA78M33QDCYRG4Q1…
Hey Cisco,
Have you checked that the hall power of 5V is applied on the EVM? This would need to be applied externally as the board only generates 3.3V so you need to switch the hall jumper to external and apply the voltage externally.
Best,
Akshay
…
