Part Number: DRV5013 Other Parts Discussed in Thread: DRV5032 Hi Sir,
My customer would like design hall sensor to meet the below condition to detect the case door open and close for the revised charge case design
Open: 7.2mT
Close: 16mT
DRV5013BC seems…
Hi Shlomi,
Apologies I couldn't follow up on this. Please give me a day, looks like there is no information on a single ended hall as its not mentioned as supported in the datasheet, I need to confirm with the design team if this works.
Thanks,
Sachin…
Hey Jerry,
I think I understand now. Is it also correct that you are using the Hall effect sensor to define the end of travel? I.e. the end of travel in this case is not a physical end of travel (like the closing of a laptop lid). The cam is capable of…
Part Number: DRV5032
Hi team,
If customer will overlap DRV5032FA & DRV5032FD in the board layout (one of the two to mount on the board), could customer connect both of pin3 together?
BR, SHH
Part Number: DRV8350H-EVM Other Parts Discussed in Thread: DRV8350 , DRV5021 , MSP430F5529 I have referenced the DRV8350 EVM and have a new design , now it indicated my HALL SENSOR error. I have used the oscilloscope and measured the Connection end of Hall…
Part Number: THS4531 Tool/software:
Good morning,
NOTE: it is possible that you already got this question from your collegue Jackson Wightman at the Power Management Forum because I asked for a stable current source for our Hall sensor but I will explain…
Part Number: DRV5032 Tool/software: Hi,
I am planning to use DRV5032 in my design and am in the initial design stages. I would like to use the Magnetic Sensing Proximity Tool for some initial calculations.
In the Design Tool sheet, I see a section called…
Part Number: DRV8350F Other Parts Discussed in Thread: UCC3626 , DRV8350 , DRV8350R
Tool/software:
We have a motor controller design using UCC3626 in 4 quad mode. To power the external N-FETs we are planning on using DRV8350.
1: are there any known issues…
Hi Ito, I had an error in my first response, so I corrected it. I had said "frequencies" but meant to say "sensitivities". My apologies for any confusion.
For my understanding, when the buttons become unresponsive, do you mean they…
THX
So then if optoisolators are not going to work with UCC25660x.Then How would i design a optocoupler FB for my circuit?
I also plan to have a Hall effect sensor for over current protection ( i am also open to other types like shunt + INA IC and other…
