Part Number: INA310A Other Parts Discussed in Thread: INA310B , INA301 , INA201 , INA381 , INA293 Dear Sirs,
do you have a TINA model (or PSPICE) model for the INA310A and INA310B?
Many thanks and kind regards.
Joern Ihlenburg
Part Number: INA201 Other Parts Discussed in Thread: INA301 , INA202 dear supporting team,
my customer is using INA201 in overflow protection circuit, the Rs is 0.67mOhm, and the overflow current threshold is 25A. the sch is as below, they want to know which…
Part Number: INA201 Other Parts Discussed in Thread: LMP8601 , INA210 , INA199 hi dear supporting team,
my customer want to get a current sensing solution which sense 12A current from +/-5V line, the precison need be 3mA. do we have proper solution?
I saw…
Other Parts Discussed in Thread: INA201 Hi,
I'm building a high side switch for overcurrent shutdown device using INA201 like in Figure 29 page 15
I need to withstand milstd1275 spec which means that I need to withstand surge voltages of 100V. Can…
Other Parts Discussed in Thread: INA201 , INA301 I want to use the INA201 without latching function. It's not described well in the datasheet. Should I connect RESET to ground to prevent CMP OUT latching?
Thank you
Other Parts Discussed in Thread: INA201 I have a design that could use the INA201 to sense current but there would be times where there is no Vs supply voltage while the sense inputs Vin+- are at 5V. Will this damage the IC?
Other Parts Discussed in Thread: INA301 Hello Forum; I am wanting to sense a 5V-3.1V rail current and use this same rail for the IC VCC. I don't see any examples of this so wanted to ask the experts if this is acceptable.
Other Parts Discussed in Thread: INA201 Hi,
I am new to battery management ,using INA201 current monitor and with Coulomb counting Algorithm we need to develop with Current shunt monitor which gives current in terms of voltage , which is in proportional…
Hello Pete,
following the schematics.
I use about 43 blocks like this and the problem comes if the "V13" that supply the INA201 is over 14,8 -15 V. About the half of the INA201 comparator output is pulled down to gnd also if the input voltage…
Other Parts Discussed in Thread: INA201 , INA200 , INA202 Hello all,
I'm thinking of using INA201 to check some power supply status (ON/OFF) based on measured current.
Let's say I have to trig if current is about 10% of max current. To get more that…