Part Number: INA240-Q1 Other Parts Discussed in Thread: INA282 , INA240 Hi team,
My customer wishes to replace INA282 by INA240 and have few questions regarding the datasheet spec, could you please help to clarify the following questions:
1. Is…
Part Number: INA282-Q1 Hi team
INA282-Q1 D/S say Input bias current = TYP 25uA per pin.
so total input bias current would be TYP 50uA(= 25uA x 2) for two input pins ?
further, may I know total input bias current for two input pins at Vs = 0V and…
Dear Matt,
The first thing I would recommend to try is removal of the output capacitor. The INA282 does not like to drive capacitive loads. If you check the datasheet, the maximum Capactivie load allowed for no sustained oscillations is 1nF.
The…
Other Parts Discussed in Thread: INA282 Hi Team,
my customer would like to meet 100V / 500mS surge voltage test requirement
they change the circuit as following, add 3.01kohm and zener diode at INA282 input side
may i have your help to estimate…
Part Number: INA282-Q1 Other Parts Discussed in Thread: INA282 , INA210-Q1 , INA199-Q1 , INA301 , INA180 Dear*,
I want to measure current from 0A to 20A on the low-side.
1) What is the proper connection of INA282 REF1 and REF2 pins if:
- I have…
Part Number: INA282 Other Parts Discussed in Thread: LM25119
Hello,
I need to measure the voltage from 2S (7.4V) up to 6S (22.2V) LiPO batteries.
I have seen the INA282 but I am not sure if I use that or there are any alternatives that can serve…
Hi Tomoaki,
The INA282 Architecture itself already achieves a very high noise rejection ratio, would you be able to describe what issues you're facing in greater detail? Also, what is the bandwidth requirement for the part?
