Part Number: INA296B I use an INA296B3 to sense an high side over current according the following circuit:
The measurements with a static current of +20A through the shunt resistor cause an input voltage differential of +10mV (IN+ to IN-).
The voltage…
Part Number: INA296B-Q1 Hello team,
In the D/S of INA296B-Q1, there are below statement highlighted in yellow. Could you explain more clearly why TI doesn't recommend a single-ended measurement with this configuration?
1.
Regards,
Hirata
Part Number: ADS8355 Other Parts Discussed in Thread: OPA2863 , INA296B , , ADS7853 Tool/software: Hi, we would like to use ADS8355 to sample two legs of low side current of a H bridge, The current sensing are using INA296B (we will also evaluate using…
Part Number: INA138 Other Parts Discussed in Thread: INA296B , INA169 , INA168 , AMC1301 Tool/software: I am looking at a design example for a high side current sense for systems with very high common mode voltage.
https://www.ti.com/lit/an/sboa295…
Part Number: INA169 Other Parts Discussed in Thread: INA296A , INA296B Hello team TI,
I'm starting a project for a current monitor, with the following characteristics:
- voltage in the range of 30VDC to 70VDC
- maximum current of up to 400A (Imax…
Part Number: INA293 Other Parts Discussed in Thread: INA296B , INA296A Tool/software: Hello everyone,
I'm looking to measure AC current and observe its frequency characteristics up to 1MHz. I've chosen the INA293 for this task, but as a beginner with…
Part Number: INA290 Other Parts Discussed in Thread: INA296A , , INA296B , INA293
Hi, i am using INA290A3. Like typical circuit the following.
My circuit;
When Vin reaches about 0.7Vdc Vout goes 1Vdc. This situation does not occur below…
Part Number: INA296A Other Parts Discussed in Thread: INA296B , INA241A , INA241B , INA240 Hi team,
Do we have PSpice models available for the following "preview" devices yet?
- INA296A
- INA296B
- INA241A
- INA241B
Thanks,
Jacob
Part Number: LMP8645 Other Parts Discussed in Thread: INA296A , INA293 , INA290 , INA296B , INA280 , INA281
Hi Team,
Customer is using LMP8645 for one square wave current sensing, during the debug, they found the VOUT response of LMP8645 is very slow…
Part Number: INA236 Other Parts Discussed in Thread: INA240 , INA296A , INA296B Hi Team,
I promote INA236 to customer for current sampling, but they concern the respond speed of INA236 and the occupation time to I2C Bus. They think analog sampling…
