Part Number: TPS650861 Other Parts Discussed in Thread: IPG-UI Hello, Using OTP Generator (TPS65086100 OTP Generator V2p5.xlsx) I have 2 lines "missing" ...
{register: 'SWA1_CTRL_EN2', value: 0x1F},
#N/A
{register: 'LDOA2_CTRL_EN1…
Hi Conor,
Thank you for your interest in the TPS6521855 PMIC!
1. General method for writing data into internal ROM
Yes, I2C can be used to communicate and configure this device. The entire TPS65218x PMIC family is user programmable with EEPROM.…
Hello,
Thank you.
understood.
Also, is it necessary to install the software in the URL (linked here: https://www.ti.com/tool/USB2ANY ) ?
USB2ANY Explorer Software — SLVC695.ZIP
Or is it OK with just the following software that was answered…
Hi Gareth,
We have a program called IPG-UI that can be used to interface with the PMIC device, but this is usually done in tandem with either the device EVM or a booster pack . Go to the following page and you can find the correct IPG-UI download for…
Part Number: TPS650861 Other Parts Discussed in Thread: IPG-UI Hi,
I am trying to control power on sequence for CPU with CTL pin, after configuring program mode in address 0X38, but it didn't output correctly. In the end, we found also a need to configure…
Part Number: TPS650861 Other Parts Discussed in Thread: IPG-UI , The data sheet describes well the PGOOD to GPOx masking trees. I'm having difficulty figuring out the CTLx & PGOODx mapping to the converter Enable inputs programming from the datasheet…
Part Number: TPS65218 Other Parts Discussed in Thread: IPG-UI , USB2ANY , , Hi All,
Please tell me about the GUI of the TPS65218EVM. I'm trying to connect with IPGUI, but I can't connect. Do you know the reason why you cannot connect?
Best Regards…
Hi Moshe,
A note before my next answers: If you are using the BOOSTXL-TPS650861 and the MSP430F5529 USB LaunchPad , you should be able to connect the boards to your computer with a USB-A to Micro B cable. The USB2ANY adapter is only necessary for communicating…
Hi Brenda,
Maybe part of my problem is my IPG-UI is not the same as yours. In my "Device Controls" section I do not have a "Program" tab. My IPG-UI version is 2.5.0.5. The "Device Controls" section only has Password and FSeal tabs. How do get the same…
Part Number: TPS650861 Other Parts Discussed in Thread: IPG-UI Hi,
I wonder if, when the PMIC is programming its OTP, the PMIC checks if the programming is correct ? Does it know if the register value programmed into the OTP is the expected one ?
…
