Part Number: ISO5852S-EP What's the value of the pull up resistor on the /RST input.
Is it the same value or 50kohms as pull up on /FLT and RDY pins.
It's not clear in the data sheet
Part Number: ISO5852S-EP Other Parts Discussed in Thread: UCC21750 Hi Team,
We are using the part number ISO5852-EP. Followings are the technical question for the same part.
1. As per data sheet (VIT+UVLO) is typ-12V , Max-13V and (VIT-UVLO) is…
Part Number: ISO5852S-EP Tool/software: Hello,
My question is regarding the static sink current capability of the DESAT pin in the ISO5852S-EP part. The datasheet specifies that the Blanking-capacitor discharge current can range from 9mA (min) & 14mA…
Part Number: ISO5852S-EP Other Parts Discussed in Thread: ISO5852S we are using a schottky diode ( NRVBAF3200T3G) across desat pin to limit the negative voltage spikes. As per the ISO5852S datasheet this pin will withstand up to -0.3V. as per the selected…
Part Number: ISO5852S-EP Tool/software:
I would like to measure the Low to high propagation delay , high to low propagation delay in my application. In my application gate voltage will raise from -8V to 15V, as per below image to measure the low to…
Part Number: ISO5852S-EP
Hi All,
I am using ISO5852 isolated gate driver in my inverter application. In that I have connected all the Fault signals together with a common pull up resistor to VCC. In internal circuit diagram of IC FLT pin is directly…
Part Number: ISO5852S-EP Other Parts Discussed in Thread: ISO5852S
Hi Team,
Hope you are doing good.
I am using ISO5852S in my 3 phase inverter application, In short circuit or Over current condition plannig to shutdown all the 06 IC's together…
Part Number: ISO5852S-EP Hi,
The basic calculations in Table A7.1 of AEC-Q100 (reproduced in figure) for each of the major stress components, demonstrate how one can derive the reliability margin between the component (specification) space and the application…