Part Number: ISO6740 Other Parts Discussed in Thread: ISO6760 , , ISO6741
Hi team,
My customer would like to know the VCCI threshold voltage to output default for ISO6740, ISO6741, and ISO6760.
Which one my customer should follow?
1. VCC<=1.05V described…
Part Number: ISO6740-Q1 Other Parts Discussed in Thread: ISO1212 Hi Team,
Our customer is looking for a 4-channel automotive isolator to determine if a 12V/24V signal is on or off.
For example:
- If the break light of the car is on, the voltage rises…
Hi Itoh-san,
The high-Z outputs occur when the output circuitry is entirely powered down. This occurs in the range from 0V up to potentially 1.05V. Table 9-2 in the datasheet is a more generalized or high level look of the device behavior. In reality…
Part Number: ISO6740 Hi team,
Could you please let me know the input pull-down resistor tolerance value of ISO674xF?
My customer would like to check it to make sure if the input is correctly pulled down with the external resistors.
Regards,
Itoh
Part Number: ISO6740 Other Parts Discussed in Thread: STRIKE Hi team,
Could you help me to clarify the ESD specification of ISO6740?
I'd like to clarify the bias condition of each pins under the HBM and CDM tests.
In HBM and CDM, it is described as…
Part Number: ISO6740-Q1
ISO6740QDWRQ1 is used in our design as shown below, the sense signals(INx and OUTx) are of 5V level and VCC=3.3V. According to the datasheet INx and OUTx maximum voltage rating is VCCx+0.5, but we wanted to know if INx and OUTx…
Part Number: ISO6740 Other Parts Discussed in Thread: ISO7740 , ISO7740-Q1 , Hi
Please help with si8640 comparison difference table
Si864x Data Sheet (mouser.tw)
Part Number: ISO6740 Other Parts Discussed in Thread: ISO6741 , Hello Support team,
My customer need 3ch forward only and they would like to design to use either ISO6740 or ISO6741, due to delivery risk. They ask questions.
*Can NC pin connect to GND?…
Part Number: ISO6740 Hi team,
I received a question from the customer.
The customer is concerned about min time of propagation delay time at 5-V supply.
I understand that only Typ and Max are defined.
From the PWD, If L->H tPLH is 18 ns (max) and immediately…