Part Number: ISO7041-Q1 In datasheet (SLLSFN3 / June 2023) there are Table 5-1 :
ISO7041-Q1 Automotive, Ultra-Low Power Four-Channel Digital Isolator datasheet
"Input, channel A-D. 300-Ω series resistor recommended "
and same for output channels…
Part Number: ISO7041-Q1 Other Parts Discussed in Thread: ISO7041 , ISO6741-Q1 We plan to use the digital Isolator ISO7041-Q1 – and / but we need a supply voltage of 1.8V.
On the TI-webpage we can search/filter for digital isolators with 1.8V and…
Part Number: ISO7041-Q1 In the datasheet of the ISO7041-Q1 in the chapter “8.4 Functional Modes” there is the input “Refresh enable ENx” shown but the device has no such pin.
? Question 1a: Does the outputs “OUTPUTx” also have…
Part Number: ISO7041-Q1 Other Parts Discussed in Thread: ISO1640 , ISO7041 I need low power ibidrectional I2C cominication , ISO1640 is usefull for this aim,but power consumption is high, so I want to design I2
C isoleted cominication with digital isolator…
Part Number: ISO7041-Q1 Hi Expert,
Customer want to use ISO7041QDBQRQ1 for LIN communication isolation. See the block diagram as below.
Do we must need to add a 300 Ω series resistor in our LIN isolation application? What is the purpose of 300ohm…
Part Number: ISO7041-Q1 Other Parts Discussed in Thread: ISO7041 , Team,
ISO7041 and ISO7041F are ATEX certified (per certificate CSANe 20ATEX2003U).
How about ISO7041-Q1, is it also ATEX certified, or not?
Thanks for your help.
Part Number: ISO7041-Q1 Other Parts Discussed in Thread: ISO7041 , Hi Team,
I noticed that the non-Q1 version of the ISO7041 has a wider temperature range compared to the Q1 version. Why is that? We would normally think that automotive grade devices should…
Part Number: ISO7041-Q1 Other Parts Discussed in Thread: ISO7041 Hi Team,
My customer is replacing ISO7041 with ISO7041-Q1.
ISO7041-Q1 recommends 300Ω series registers for INAA/B/C/D, and OUTA/B/C/D.
What is the reason for this?
What problems can…
Hi Stefan,
Thanks for reaching out and welcome to E2E!
I have answered your questions below:
Stefan Brehm said: Are there information in the datasheet which show that parameter or is possible to calculate it with a datasheet parameter as shown below?
…