Part Number: ISO7740-Q1 Other Parts Discussed in Thread: ISO7741-Q1 Tool/software: MOUSER and DIGIKEY stating that this part is Scheduled for obsolescence and will be discontinued by the manufacturer. . Then what is the alternate or Drop in replacemnet…
Part Number: ISO7740 Other Parts Discussed in Thread: ISO7820 Hi,
Yes, we've already seen the TDDB plot and we will continue to discuss that, but idealy we need Failure Modes and Distribution with the item 'lost of isolation'. Is it possible for TI…
Part Number: ISO7740 Other Parts Discussed in Thread: ISOM8110 , ISOM8711 , ISOM8710 , ISO8110 Tool/software: Hi TIer
Could you help me find the below ISO chip good alternatives?
Thank you very much.
H11L1(Onsenmi ):
EL2501-G(EVERLIGHT):
6N137SD…
Part Number: ISO7740 HI Sir
I Try to use the ISO7740 to replace ADI/ADUM1410
original circuit is work correct, but after change it, the system no work
after check the data sheet
i found the ADI/ADUM1410 pin 10 Is a function pin & connect to ground…
Part Number: ISO7740-Q1 Other Parts Discussed in Thread: ISO7741-Q1 , ISO7741 Tool/software: Hi,
i am using ISO7740DBQR IC for digital isolator purpose
attached the schematc,problem is at INC input GPIO is become High from MCU,but output side OUTC…
Part Number: ISO7740 Other Parts Discussed in Thread: ISO7820 Hello,
We discuss internally the lost of hvdc (high voltage) isolation due to iso7740 (on also on iso7820...).
I guess that the lost of isolation is very rare (reading different document…
NC pin = Not Connected pin
It is most recommended to leave the NC pin floating . The NC pin does not have to be tied to VCC, GND or any other pins and can be left floating
As long as the absolute maximum ratings are taken into consideration, GND or…
