Search tips
Showing 45 results View by: Thread Post Sort by

  • ISO7762-Q1: IBIS model

    TI Thinks Resolved
    Part Number: ISO7762-Q1 Hi, My customer is looking for IBIS model of ISO7762FQDWQ1. I see IBIS model of industrial grade available online. Can this be used for full validation of the device? Or do we have separate IBIS model for auto qual device?

  • ISO7762: to replace ISO1541 and ISO7731

    TI Thinks Resolved
    Part Number: ISO7762 Other Parts Discussed in Thread: ISO1541 , ISO7731 , TPS23881 , TPS23882 , This design guide ( http://www.ti.com/tool/TIDA-050026-23881 ) recommends ISO1541DR for I2C and ISO7731DWR for Reset, INT and OSS. Can I use ISO7762DWR which has…
    • Answered

  • ISO7762: ISO7726 RoHs compliant

    Resolved
    Part Number: ISO7762 Customer Question. Is the ISO7762DWR compliant to the new RoHS 2015/863/EU directive? Thanks, Regards, Joe
    • Resolved

  • ISO7762: propagation delay question

    TI Thinks Resolved
    Part Number: ISO7762 hi support team, may I have propagation delay time curve in full range operation temperature.
    • Answered

  • RE: ISO7762: RS485 data getting corrupted

    Resolved
    Dear Mr.Rao , The above suggestion did not solved the issue so previously we were using ISO7762F & then we replaced it with ISO7762 , it is working fine now , However thank you for your support . We have given go ahead to our EMS vendor for its…
    • Answered

  • ISO7762: Negative voltages

    Resolved
    Part Number: ISO7762 Can the ISO7762 be used to translate to a negative voltage? Can it have, say, +3.3V on one side and -3.0V on the other?
    • Resolved

  • ISO7762-Q1: Is there timing requirement to work ISO776x-Q1 after power up VCC?

    TI Thinks Resolved
    Part Number: ISO7762-Q1 Hi team, Our customer asked us about a question to ISO776x-Q1. Is there timing requirement to wait ISO776x-Q1 between power up VCC and operation? Does customer need to wait some time after power up VCC? Regards, Nishimura

  • ISO7762: Power supply voltage

    TI Thinks Resolved
    Part Number: ISO7762 Hello! Can I use power supply voltage of VCC1 and VCC2 differently in ISO7762? I want to use VCC1 = 5V and VCC2 = 3.3V. Thank you.

  • ISO7762: meaning of reinforced (needed for EN61010)

    TI Thinks Resolved
    Part Number: ISO7762 Other Parts Discussed in Thread: ISO7840 Hi, a customer is working on a project wihere Viowm 1000VDC(707VAC) with EN61010 reinforced is needed. ISO7762: ISO7840: At the two digital isolators the datasheet refers to EN61010. Eg. ISO7840…

  • RE: SN74LVC2G125: Dual Bus Buffer Gate With 3-State Outputs

    Hi Emrys, Thanks for answer. Please find attached Skeleton Here, I have used ISO7762 in multiple slave configuration, But due to output nature of ISO7762--> MISO1 Signal Pulling down due to other ISO7762 and viceversa and we are not getting SPI Slave…

Didn't find what you are looking for? Post a new question.