Part Number: IWR6243 Other Parts Discussed in Thread: AWR2243 Tool/software: Hi,
There is no simulation model at IWR6243 product page. Can customer use below simulation model of AWR2243 to simulate IWR6243?
https://www.ti.com/product/AWR2243#design-tools…
Part Number: IWR6243 Tool/software: Hello Expert,
I would like to evaluate a Cascaded IWR6243 System.
Could you please advise on the simplest way to configure and test the performance of this board?
Additionally, do we need to flash the IWR6243 before…
Part Number: IWR6243 Other Parts Discussed in Thread: AWR6243 , Tool/software: Good morning,
I am a design leader at Magna Electronics R&D department.
I have a question related to AWR6243 and IWR62343.
AWR6243 MMIC is not referenced on the site…
Part Number: IWR6243 Tool/software: Hi Team,
i am currently trying to calculate the Received Power of the IF Signals i am receiving with a Radar System using the IWR6243. I am receiving ADC Data and performing the Range FFT and the Peaks in the Spectrum…
Part Number: IWR6243 Tool/software: The datasheet says you can short VIN_13RF1 and VIN_13RF1, but only mentions this on lines discussing using 1.3V inputs and the internal LDOs. Is it recommended, or at least acceptable, to short these lines when supplying…
Other Parts Discussed in Thread: IWR6243 , IWR6843 Dear colleagues,
Datasheet of IWR6243 claims that there is no on-chip memory.
Does it mean that it is possible to use any memory size?
What are the limitations on memory size and other technical demands…
Part Number: IWR6243 Tool/software: Hello expert,
Our customer wants to evaluate the higher resolution sensing with IWR6243 cascade EVM.
What is the simple way to check the performance of this board?
Regards,
A.Fujinaka
Part Number: IWR6243 Tool/software: Hi Team,
I recently opened up some threads about weird configuration behavior of the IWR6243 with a custom software based on the mmWave Link Liberary from DFP 6.4.1.0 Package.
See: https://e2e.ti.com/support/sensors…
Part Number: IWR6243 Other Parts Discussed in Thread: AWR2243 Tool/software: Hi Team,
i am currently facing the following issue when i try to set the profile configuration of a cascaded IWR6243 Radar-System. I am trying to use the following Config Values…
Hello Akif.
Here is some documentation that might help with the calibration procedure for the cascade devices . And with respect to your setup, an idle time of 3us has some implications regarding whether inter-chirp dynamic power save will be enabled(if…
