Part Number: LAUNCHXL-F28379D Other Parts Discussed in Thread: SYSCONFIG Tool/software: Hi all,
I am trying to use the MCU Signal Sight plugin on my launchxl-f28379d. I am able to get it running with data being captured every 1 ms (using a Timer interrupt…
Part Number: LAUNCHXL-F28379D Tool/software: Hi,
my board stop working and now dosen't want to power up anymore. Even the three leds don't want to power on too. When I plug the USB, the main chip start to heats a lot and I detected a shorted circuit…
Part Number: LAUNCHXL-F28379D Tool/software: I also have some queries,
As per IEC 61000-3-2 , what are the equipment class category and harmonic emission levels for the LAUNCHPAD F28379D kit ?
As per IEC 61000-3-3 , what are the limits for short…
Part Number: LAUNCHXL-F28379D Tool/software: Hello team,
I am working on a ADC sampling code and i wanted to transmit the adc value over CAN. I am using a basic code, basically the boot start code. I read the value of ADCIN 14 in a variable and i want…
Part Number: LAUNCHXL-F28379D Tool/software: Hello Team,
I am working on a LAUNCHXL-F28379D and I wanted to transmit all my data through the board to a central motherboard through CAN communication.
I want to transmit the following data -
Digital…
Part Number: LAUNCHXL-F28379D Tool/software: I am using the SPI module (set up for 8 bit data width) and I would be sending up to or even over 256 bytes within 1 message. The issue I am facing now is that the MCU will only send 16 bytes/words at a time…
Part Number: LAUNCHXL-F28379D Other Parts Discussed in Thread: TMDSCNCD28379D Tool/software: Hi there,
I'm new to TI processors coding through CCS. I purchased Launchpad F28379D(336 pin ZWT package) considering its high ePWM count of 12 numbers. But…
Part Number: LAUNCHXL-F28379D Tool/software: Hello , I bought LAUNCHXL-F28379D an I tried blink blue led(GPIO31). But there is no resistor in R39 which connected blue led. İs it normal or is there a problem?
Part Number: LAUNCHXL-F28379D Other Parts Discussed in Thread: SYSCONFIG Tool/software: Hi team,
I am trying to run the can_ex1_loopback example on LAUNCHXL-F28379D but I am not able to see the data on can analyzer tool, I have also changed the pins…
Part Number: LAUNCHXL-F28379D Tool/software: I have worked for some years with LauncherPad 28379D ver:1.2
It always worked fine, but one day with a brand "new" board, my old codes stopped working. After investigation, I saw the "new" board was an older…
