Part Number: LDC1000EVM Hello,
Is it possible to use this EVM for humidity sensing? It says in the datasheet that it can detect presence of moisture, but the customer will be measuring the humidity of a chamber.
I've been searching the TI website…
Part Number: LDC1000EVM Other Parts Discussed in Thread: LDC1101 Hi, I purchsed LDC1000 EVM. And I have a one question.
I'm not good at English. So I have difficulty in understanding datasheets.
As I understand, LDC1000 EVM requires the maximum, minimum…
Part Number: LDC1000EVM Other Parts Discussed in Thread: LDC1001
Hi, I'm Tien.
I'm new to LDC1000evm. I ran into some problems with the evaluation module.
I had to upgrade the firmware for LDC1000 because at first, it doesn't work. (similar to this…
Part Number: LDC1000EVM
Hi Team,
The customer is using LDC1000EVM. He watches the video that you can change the LDC1000EVM default sensor coil tp a coil of your choice.
In the video, the engineer uses a Impedance analyzer to measure the Rp_MAX,Rp_MIN…
Part Number: LDC1000EVM Other Parts Discussed in Thread: LDC1101 , LDC1614 I had earlier installed gui 1.0.4.1 version which was not supporting the change of Rp value for finding out the optimal Rpmin and Rpmax values like in the empirical procedure.…
Part Number: LDC1000EVM Hello everyone,
I am currently trying to use the LDC1000EVM computer with my Dell Latitute E6320 with Windows 7 64bit. However, I am apparently having problems with its driver.
Windows actually recognizes the ' MSP430-USB Example…
Hi Luke,
so the easiest way to solve this is to install an old firmware version for the ldc1000evm (see: https://e2e.ti.com/support/sensor/inductive-sensing/f/938/t/324500 ) . Once you installed the old firmware you are able to use the USB CDC protocol…
Part Number: LDC1000EVM Other Parts Discussed in Thread: LDC1612 , LDC1614
How I can modify an LDC to measure the displacement of the glenoid component loosening from the bone substitute (basically measure the edge displacement as seen in…
Part Number: LDC1000EVM Other Parts Discussed in Thread: LDC1101 Hello!
I made a sensor, about 220 turns with a 0.2 mm wire, a winding diameter of about 1.5 cm. I chose the frequency below to see the difference between ferrous metals and non-ferrous…
