Because of the Thanksgiving holiday in the U.S., TI E2E™ design support forum responses may be delayed from November 25 through December 2. Thank you for your patience.
Dear John,
Thanks for your help.
During the "bad" behavior, does a power-down/power-up sequence of the LDC fix the problem? We can not test this since our devices are installed in several cities and we can not remotely plug/unplug the power, so the battery…
Part Number: LDC1001-Q1 Other Parts Discussed in Thread: LDC1001 Tool/software: Hi,
The datasheet says: Remote sensor placement (decoupling the LDC from harsh environments).
How far away can the LDC1001 and microcontroller be from the sensor? Does the…
Part Number: LDC1001-Q1 Tool/software:
We are looking for a technology for a speed sensor for turbochargers (detecting the blades)
The electronics needs to withstand 150ºC
Single output push/pull stage
Important Low Speed requirement: Minimum output…
Part Number: LDC1001 Tool/software: Hello, We use the LCD1001 sensor to detect the presence of metal objects on our product.
We are able to detect several types of objects of different sizes, but larger objects cause the sensor to overload. We can't currently…
Part Number: LDC1001 Tool/software: Hi team, OSC status becomes 1. What could be the reason for this status to be 1? If the IC was swapped to another device, the OSC status is 0. BR, Kengo.
Part Number: LDC1001-Q1 Other Parts Discussed in Thread: LDC1001 Tool/software: I've been trying to adjust a filter cap on an existing sensor (CFA and CFB pins). The datasheet says to adjust the cap until the signal on the CFB pin is 1 Vp-p. The board…
Part Number: LDC1001-Q1 Hi all, I am using the TI LDC 1001-Q1 as proximity sensor to detect metallic objects. The LDC is connected to a Microcontroller and to an external squared coil with an inductance of 220uH (inner diameter/ outer diameter = 0.86…
Part Number: LDC1001 Other Parts Discussed in Thread: LDC3114 I would like to simulate the behavior of the LDC1001 in ANSYS Simplorer. Is there a sensor model available (Spice, SML, Modelica, VHDL-AMS)?
Part Number: LDC1001 Hello TI, as in the question, what is the use of the amplitude and amplitude settings in the LDC settings (1V/2V/4V)?
1. I tried Rp stability (sample data for a long time)
2. Influence of temperature drift during cold start
3. The…
Part Number: LDC1001 Hi,
I just re-laid out an existing board and while checking the signal integrity I see that the LDC1001’s CFB waveform doesn’t stay within the 1V limits on one of the two new prototypes, see CH1 (yellow) on the attached…
