Part Number: LDC1312-Q1 Other Parts Discussed in Thread: LDC1312 Hi
I am using LDC 1312 in one of our position sensor.
i got coil PCB designed from TI tool.
Position is sensed and analog output is given as a representation of position.
One failure observed…
Part Number: LDC1312-Q1 Hello Team,
customer is using LDC1312-Q1 with CLKIN=16MHz and has a sensor resonance frequency of 3.95MHz.
Is it possible to work with a deglitch filter configuration of 3.3MHz? Any concerns?
Many Thanks
Josef
Part Number: LDC1312-Q1 Other Parts Discussed in Thread: LDC1312 Hello
My Customer will Design the Inductive sensor using LDC1312.
The maximum size of the PCB is 7mm x 7mm.
Could you suggest design When Sensor-Target Distance is over 5mm?
It should be…
Part Number: LDC1312-Q1 I was trying to get device ID using address 7F and also manufacturer ID 7E
I send over I2C:
1.byte 2.byte 3.Byte 4.byte 5.byte
0x54 0x7F 0x55 0xff 0xff
I getting ack but I can not get 4.byte and 5byte. (I am receiving 0xff) …
Part Number: LDC1312-Q1 Other Parts Discussed in Thread: LDC1312 Is it ok to make a 4 layer board, with two layers of coil, one layer for ground and one layer for LDC1312 and other components. I want to keep size of the board not more than the size of…
Part Number: LDC1312-Q1 Other Parts Discussed in Thread: LDC1312 I was trying to get device ID using address 7F and also manufacturer ID 7E
but to my observation the reply from LDC1312 was different so is there a problem
in I2C communication, also what…
Hello,
Thanks for considering to use Texas Instruments, sorry you have encountered obstacles with getting your evm up and running. Can you try the suggestion under "Q1: I have 'bricked' my LDC1312, LDC1314..." here ?
Hello Sagar,
The LDC0851 is not designed for automotive applications. You will need to use a device with the '-Q1' suffix like the LDC1312-Q1, LDC1314-Q1, and the LDC1614-Q1. I will note that these operate differently from the LDC0851 in that they need…
Hello Jim,
You can re-flash the EVM following these directions:
Q1: I have 'bricked' my LDC1312, LDC1314, LDC1612, or LDC1614 EVM during a failed firmware upload attempt. What can I do to restore functionality?
Best Regards,
Justin Beigel