Part Number: LDC1314 Tool/software: Hello experts,
My customer is about to go into production with LDC1314 next month, and they are having some occasional sensing errors. For example, in some cases the read data changes drastically when it is not supposed…
Benedict,
Would it be possible to look at the sensor waveforms using a oscope and high impedance probe?
I'm proposing this because for troubleshooting, its usually good to start at the inputs.
If you can do this, please try to get some images of the…
Part Number: LDC1314 Tool/software: Dear Support,
we have observed, that some sensors report significantly lower offset value when tested without load than the majority of products. All come from the same batch of components and PCB.
Layout is as follows…
Part Number: LDC1314
Tool/software:
Hello experts,
My customer is trying to do mul ti-channel sensing with LDC1314 and trying to test by with below register values set.
Below 2 codes are example codes that my customer has written, could you please review…
Part Number: LDC1314 Other Parts Discussed in Thread: TMAG5273 Tool/software: Hello,
I am working on a product which requires the code to detect the bezel rotation (by hand) at 1 Degree Accuracy. The device will have a similar edge like Nest Learning…
Part Number: LDC1314 Tool/software: Hi,
I'd like to know How to use IBIS model in ADS circuit simulation.
Which ADS symbol can be used for LDC1314 IBIS model.
Thanks,
Part Number: LDC1314-Q1 Hello team,
In the datasheet of LDC1314-Q1, there is no thermal pad dimension. Could you please let me know or share the detailed land pattern data?
Thanks and regards,
Sam Lee
Part Number: LDC1314 Hi,
I have an application where I'm scanning the 4 channels with the AUTOSCAN_EN=1. The coils are off board, thus it is possible that the INXY ports are shorted to GND.
The question: Can a permanent short to GND destroy the LDC…
