Because of the Thanksgiving holiday in the U.S., TI E2E™ design support forum responses may be delayed from November 25 through December 2. Thank you for your patience.
Part Number: LDC1314EVM Hi TI Team,
Thank you for your support.
One of our customer asking "How to turn Power-off after Powered?"
LED is flashing. But he don't know how to turn it off.
Can you give some advice?
Kind Regards,
Takash…
Hello Daniel,
Looking further into the differences between the firmware versions, there is a lot of dependence on the USB communication that is happening with the GUI software to determine the timing. The firmware doesn't change too much in this portion…
Part Number: LDC1314EVM Hello,
I got a LDC1314EVM (SV601126-001) and would like to know which is the proper firmware, meaning RevA or RevB?
Thanks,
Daniel
Part Number: LDC1314EVM I have three questions.
1. Is Version1.10.0 the latest?
2. If I raise InputGain from 1 to 16 at "Configuration" of MENU and also give a value(3000) to DataOffset, the sampling cycle of the 16-bit result(DATA_CH0 in Registers) will…
Part Number: LDC1314EVM Other Parts Discussed in Thread: LDC1314 Hi Sir,
A customer used WEBENCH® Inductive Sensing Designer ago, but now he can not find it.
I can find the coil designer below.
https://webench.ti.com/wb5/LDC/#/spirals?origin=pf_panel&lang_chosen…
Part Number: LDC1314EVM The EVM popsup in the device manager as a COM port but when I run the Sensing Solutions EVM GUI-1.9.4 I does not connect to the device.
I suspect it might be looking for specifc PID and this module was produced with a different…
Part Number: LDC1314-Q1 Dear team,
We found the EVM PCB picture from TI website, it seems only 2ch SENSOR only, but I need 4 channels SENSOR for test LDC1314-Q1.
Please let me know your comments. Thank you.
