Hello Suzuki-san,
My apologies for the delayed reply. I was on vacation all of last week.
No, your customer does not have to specify lead thickness when ordering the LDC1614-Q1.
Best Regards,
Part Number: LDC1614-Q1 Hi team,
I measured Rp using Network analyzer according to the guideline in the apps note snoa936.pdf,
to find the right CHx_IDRIVE value in LDC1614-Q1 register.
1) I removed Cpar and no target metal close to the sensor and measured…
Part Number: LDC1614-Q1 Hello Team,
I made the touch on metal board using LDC1614-Q1, but found the LDC1614-Q1 output continued to increase gradually.
Could you let me know the possible reason and countermeasure against it?
Regards,
Hirata
Part Number: LDC1614-Q1 Other Parts Discussed in Thread: LDC1614EVM Hello team,
When external clock is used for the LDC1614-Q1, are there any tolerance recommendation for the external clock tolerance?
How to think about this?
Regards,
Hirata
Part Number: LDC1614-Q1 Other Parts Discussed in Thread: LDC1614 Hi team,
I have a question about the DATAx read behavior at multi-channel mode.
When in multi-channel mode, does LDC1614 keeps the value in DATAx register unless the user read out the data…
Part Number: LDC1614-Q1 Other Parts Discussed in Thread: LDC1614 Hi team,
Could you advise the tolerance of DATAx value captured by LDC1614-Q1 if I use external clock input for frefx with 50ppm tolerance?
Does the measured DATAx result also has 50ppm…
Part Number: LDC1614-Q1 Other Parts Discussed in Thread: LDC1614 Hi team,
I designed a sensor coils for LDC1614 and found that the sensor output value from each sensor inputs have some offset due to
the difference in distance from LDC1614 inputs to each…
Part Number: LDC1614-Q1 Other Parts Discussed in Thread: LDC1614 Hi team,
I have a question about sensor coil design for LDC1614.
In page 24, 4.2.2 of LDC Sensor Design application note (SNOA930A), there is a description as below.
- Keep the inner 30…
Part Number: LDC1614-Q1 I want develop a sensing switch using Touch-On-Metal Button mechanism without either moving or bending of metal target. is it possible?
