Part Number: LEDMCUEVM-132 Other Parts Discussed in Thread: MSP432E401Y Tool/software: Hi,
I would like to integrate this EVM with an external ADC through SPI. Do I require any external debuggers to program this? Could I connect this to the CC Studio…
Part Number: LEDMCUEVM-132 Other Parts Discussed in Thread: TPS92520EVM-133
Tool/software:
We are preparing to implement Daisy chain. Use the EVAL Board to verify that Daisy chain is possible. Currently, SPI communication is not possible with EVAL…
Part Number: LEDMCUEVM-132 Hi team,
A customer tried to install the GUI for the above-mentioned part on Windows 7, 32-bit system. The installation completed without any trouble.
However, the driver for the GUI was not installed. Will the GUI for the…
Part Number: TPS92682EVM-069 Other Parts Discussed in Thread: LEDMCUEVM-132 , Hi Team,
We are trying to connect LEDMCUEVM-132 board with TPS92682EVM-069 to work with TPS92682 GUI, but after powering up, it always reporting below error on PC, can you…
Part Number: LEDMCUEVM-132 Other Parts Discussed in Thread: TPS929240-Q1 , TPS929120-Q1 Hi Experts,
Our customer is looking to control an RGB LED light strip using CanBus. Do we have a controller/connector for something like this that we can suggest…
Hello Bart,
Can you tell me about your application? What are you design requirements and what EVMs are you planning to us?
When you say software, I assume you mean GUI. Can you confirm you just need the GUI installer? That GUI only works with TPS92518…
Part Number: TPS92543EVM Other Parts Discussed in Thread: LEDMCUEVM-132 Hello,
I am trying to use TPS92543EVM + LEDMCUEVM-132 with "TPS9254x_TPS9266x_TPS9276x_EVM_GUI". When I start the application I am reciving a message that "firmware version 3…
this really just sounds like a connection issue with the MSP board or maybe a damaged MSP board. Do you have access to our LEDMCUEVM-132 ? That is the intended companion to all of our EVMs
Hi Aidan,
The MOSI pin is configured as a TTL input. I am not aware of any functional state in the device that is capable of driving the MOSI pin low. It is most likely a hardware configuration that is causing the behavior, or potentially causing damage…
Hi Lukas, Francis actually put together a manual on how to daisy chain 520s together. 2210.Instruction for Daisy Chain using LEDMCUEVM and 520EVMs.docx Good intuition to put the 682 at the end. Here is a good diagram that shows the right connections and…
