Part Number: LM10010EVM Other Parts Discussed in Thread: LM10010 Tool/software: Hi,
I want to evaluate the LM10010EVM but encountered an issue when using the GUI. Following the setup instructions I downloaded both the LM10010_GUI and CDM20600 executable…
Hi John,
I can wait until you've received the EVM. I have ordered another EVM to test on a different computer to see if perhaps my setup(FTDI drivers) was the issue. I've attached the Readme file that I followed to try to get the GUI to work. I suspect…
Part Number: LM10010EVM Other Parts Discussed in Thread: LM10010 Hi team,
This is the LM10010EVM board, the waveform captured by the P1 connector VIDC (8 pins).
and it's used to set the parameters of LM10010, please kindly help to check if there's…
Part Number: LM10010 Hi,
Does TI have a EOL plan of the LM10010? On the TI Web, had other IC is recommended. Could you give me your advice? Best Regards, Yusuke
Hello Hamonika,
AGND is the "quiet" GND node.
The GND pin of the DAC IC in the application note is referenced to the AGND terminal of the LMZ3 module. I believe this is what you should do as well. This will ensure the DAC is referenced to the "quiet…
Bob,
The voltages for TPS56221 and LM10011 may be the same or different depending on the available voltage rails. TPS56221 can operate from a supply of 4.5 V to 14 V while the supply of LM10011 can be from 2.97 V to 5.5 V. So practically, they can…
Other Parts Discussed in Thread: LM10010 , TPS7A33 Dear Sir/Madam,
Would there be any issue using the LM10010 to control the output voltage of the TPS7A33 (negative output voltage). The TPS7A33 is used for a low noise application. What affect will the…
Other Parts Discussed in Thread: TPS62110 , LM10010 Hi All,
Our customer has evaluated TPS62110 with LM10010 to adjust output voltage to control rotating speed of fan. Then how should we set the external component value especially inductor to get stable…
