Part Number: LM25037EVAL Other Parts Discussed in Thread: LM25037 Hi,
I am evaluating LM25037 design for a push pull transformer drive.
I have a question regarding using SS pin to disable the IC.
What i am observing is that with SS pin grounded…
Part Number: LM25037EVAL Other Parts Discussed in Thread: LM25037 Hi guys,
I'm thinking about using the LM25037QMT to design a boost converter that would take a 12V input from my battery and convert it to a 24V output.
I want to use a topology of…
Part Number: LM25037EVAL Other Parts Discussed in Thread: LM25037 Hi TI Team I have got your LM25037EVAL board. after verify function i have some question about softstart circuit. In schematic use SS Cap = 0.68uF. So T3 should be around 27mS. but after…
Part Number: LM25037EVAL Other Parts Discussed in Thread: LM25037 Customer ordered the EVM,but didn't mange to operate it above 1.5MH (750K each ).
What could be the reason?
Hi Keith,
The challenge with a tapped transformer is there will be step change in the operating point of the power stage and that transient will travel dierctly to the output where the output filter cap will take up some of the energy but the control…
Hi Kuramochi-san,
Unfortunatley there is no evm for the LM5037, the device is similar to the LM25037 which has an evm based on push-pull topology. You can directly replace the controller to evaluate the LM5037 on the LM25037EVAL. If you want to evalutate…
Other Parts Discussed in Thread: PMP , LM25037 , LM25037EVAL Hello,
i found the DEV Kit PMP7797 which is the right part for a project on which i'm working.
Where can i buy this part ?
Best Regards,
Martin
