Part Number: LM25088 Hello,
I am using LM25088 for my application. The input is +5V and the output are +12V, 0.8A and -3.6V, 1.2A. Please help me to review my designs.
LM25088.zip
Part Number: LM25088 Tool/software: Hi, TI expert
The datasheet of LM25088 does not indicate the power dissipation.
Can you explain how to check the power dissipation of LM25088?
Part Number: LM25088 Tool/software: Hi,
We want to use the DC/DC for the -12VDC output voltage and 100mA current, can you help to promote the solution for our request? I use the Webench to simulate that it promote the LM25088 is well,
and we need…
Part Number: LM25088 Hi
I set 22nF between pin10 and Gnd.
Try the current limit about sereval times and I find out the LM25088 doesn't work, no more PWM signal, keep about 3V(DC).
Meter the pin15 and pin13 only 2K ohm.
I don't know how to do…
Part Number: TPS2557-Q1 Tool/software: TPS2557-Q1.
I have a load switch which provides current to a System on a module (5V) whcih on boot time can take 2.5A. But drops to 1A after boot up. I have added a 21K ohm as the Ilimit resistor to this load…
Part Number: LM25088 Other Parts Discussed in Thread: TINA-TI Good days ;
I am working on CC mode Converter curcuit with LM25088.
The design requirements are listed below:
Voltage max : 8.2V
Load current :8.2A max and should be continious
Is…
Part Number: LM25088-Q1 Other Parts Discussed in Thread: LM25088 I would like to know the function of Rramp resistor in the below configuration. Datasheet recommends Rramp ony for VOUT>5V but my VOUT is 5V. And also why a 1M ohm resistor is used.
Webench…
Part Number: LM25088 It's24V to 15V DC DC
The circuit is on page4 of the attached sche
The output is 12V with no loa, with 120Ohm load it goes down to 5V' main_pcb_right_r5e2a.pdf
Part Number: LM25088 Other Parts Discussed in Thread: LM5155 , Hi team,
Does TI have a positive to negative solution? Like LTC3704
Customer needs 24V to -15V (3~5A). thanks
Part Number: LM5088 Other Parts Discussed in Thread: LM25088 Hello,
I have a design need to design a DC/DC converter, the input voltage is 5V and the outputs are -3.6V and -12V 1A. I was using WEBENCH ® POWER DESIGNER to search and found LM5088/LM25088…
