Part Number: LM25141-Q1 Tool/software: Hello Team,
My customer is asking what percent of soldering area required for normal operation.
Do we have any guide or recommendation on the numeric percentage?
Please find the attached picture with current…
Part Number: LM25141-Q1 Hello Team,
Could you please tell me about highest configurable DITHER frequency?
As far as I confirm, I cannot found any limitation information for DITHER frequency at datasheet and it just describe about nominal setting.…
Part Number: LM25141-Q1 Other Parts Discussed in Thread: LM25141 Tool/software: hi expert,
my customer use LM25141-Q1 power for SOC PMIC. now when in -20℃ or -40℃， the output is abnormal, below is the test scope(channel 3 is the output):
of course…
Part Number: LM25141-Q1 Other Parts Discussed in Thread: LM25141 , LM25149 , Hello sir,
Are there some reference circuits to enhance MOSFET drive ability? My customer wants to achieve 30A output current of LM25141. I used calculation tool to find the…
Part Number: LM25141-Q1 Hello Expert,
My customer is designing circuit using LM25141-Q1. In there circuit they will use VDDA as pull up power source for DEMB and OSC as same as EVM. On the other hands, they are considering to do on-the-fly change…
Part Number: LM25141-Q1 Hello Expert,
Our customer is considering to use LM25141-Q1.
Then, they'd like to understand this device's current limit behavior. For this, they think confirming Vout vs Iout curve as like as this is best way to confirm…
Part Number: LM25141-Q1
When the output is 16A, the output voltage is normally 5V. When the output 16.1A is present, the output voltage is not OK and the output current continues to rise until overcurrent occurs.
Part Number: LM25141-Q1 Hello, I use LM25141-Q to design BUCK circuit. The o utput voltage is 3.3V. FB PIN is connected GND to output 3.3V.
I wonder how to measure the loop phase margin and gain margin of this circuit with Bode-100?
