Because of the Thanksgiving holiday in the U.S., TI E2E™ design support forum responses may be delayed from November 25 through December 2. Thank you for your patience.
Part Number: LM26480 Hi
I am using the LM26480-Q1 to create 1.35V and 1.8V outputs via the buck converters. The input voltage is 3.3V and is stable. Currently the LDO outputs are not used.
The schematic is attached below:
The issue is that both buck…
Other Parts Discussed in Thread: LM26480-Q1 Dear all,
what is the minimal voltage for enable pins (7, 12, 17, 16) on LM26480-Q1 if the input voltage is 2.9V
Best Regards,
David.
Other Parts Discussed in Thread: LM26480-Q1 Hello, I have a question about LM26480-Q1. (VIN1=VIN2=5V)
I show below a switching wave pattern of SW2-terminal.
High peak is +6.51V, and Low peak is about -1.2V.
Does this switching wave pattern destroy this…
Dear Sir,
I have a Question.
Quiescent current "IQ" are listed in "7.6 Low Dropout Regulators, LDO1 and LDO2" of page 7 in datasheet.
Is this one of LDO value? or Is the total value of the two LDO?
Similarly, Please tell me also…
Hi,
My customer has question about QSQ-CF. Could you tell me about questoin?
[Question] My customer saw Default Option from datasheet P3 table1. QSQ-CF is UVLO be disabled. What is mean UVLO is disabled? Cold you explain this function?
Best Regards, tat…
Part Number: TPS65708 Other Parts Discussed in Thread: TPS650330-Q1 , LM26480 My application currently uses a TPS65708YZHR, which has a 5V input and creates required 3.3V, 1.8V, and 1.2 V rails. I'm trying to reduce the thermal profile of my device, and…
Other Parts Discussed in Thread: LM26480-Q1 Hello,
I want to propose LM26480-Q1 to customer, but I am concerning the problem of minimum on-time.
Please answer following questions.
Q1:
Minimum ON-Time is not explained in datasheet.
Please advise if following…
Part Number: TPS65001 Other Parts Discussed in Thread: LM26480 , TPS650330-Q1 Hi,
my customer is looking for an alternative for TPS65001 what has the same count of Bucks and LDOs. The output current should be higher than 0.6A. I already found the https…