Part Number: LM2775 Tool/software: Hello TI Experts,
I am currently designing a USB OTG power supply; the LM2775 is an excellent choice. But I have noticed something that I cannot quite understand. In the LM2775 datasheet, part " 8.2.2.4 Recommended…
Part Number: LM2775 Tool/software: Hello TI Experts,
What is the enable pin current of LM2775 ? Unfortunately i could not find it in datasheet.
ZHIYAR TAHIR
Part Number: LM2775-Q1 Other Parts Discussed in Thread: LM2775 Hi,
I am using LM2775 with Vin = 3.3V and common mode voltage = 5V. But I am getting some different outputs.
I am expecting 8.8V w.r.t ground of the total circuit. but I am not getting…
Part Number: LM2775 Hello,
We are using LM2775 for HDMI application. Can you please review the below attached schematic.
Please let us know your feedback comments regarding same.
Thanks,
Sonali
LM2775DSGT.pdf
Part Number: LM2775 Tool/software: Hi,
When EN is set to High, Vin voltage drops.
Could you tell me the cause of this?
I would like to send you the circuit diagram and waveform, so could you handle this via private message?
Best Regards,
Ni…
Part Number: LM2775 I have a LM2775configured as shown in the typical application with 10uFd input/output caps and 1uFd flying cap - all X5R.
There is a +5V rail that drives a dual LDO and a ATTINY1617. The circuit works when driven by battery. Total…
Part Number: PSPICE-FOR-TI Other Parts Discussed in Thread: LM2775 Hi
I am using LM2775 model in PSPICE for TI. In simulation, instead of connecting GND pin of device to 0v/GND, i connected to a fixed voltage(common mode voltage).
And input is 3.3V…
HI,
I would use LM2775 device, and if simulating webench, there is cut-out in the pcb bottom.
if pcb is 2 layer(top/bottom side), cut-out is picture.
but, if i use 10 layer PCB, is cut-out all layer??
