Part Number: LM3150 We need data on the " LM3150" component for our internal certification application for a new part.
Please provide the following three pieces of information:
* Delivery specifications
* Failure rate
* Estimated lifespan
Thank…
Part Number: LM3150 Tool/software: Hi there,
I use the LM 3150 to step down from 26V to 21.3 .
Input should be max. 2.3 A.
Its to charge a LiFePO Battery.
When i connect first the input at 26 V then the Battery its working.
If the Battery is…
Part Number: LM3150 Other Parts Discussed in Thread: LM5017 Tool/software: Hello:
Can the LM3150 be used to drive a coupled inductor ?
If so, can it have a "step up" conversion from 36 to 120V at 200W?
As if it was a "flyback" converter? But not…
Part Number: WEBENCH-CIRCUIT-DESIGNER Other Parts Discussed in Thread: LM3150
When I run the simulation below, it displays “Simulation Failed” and does not execute.
This simulation uses the default simulation conditions and circuit configuration exactly…
Part Number: LM3150 Hi, I'm currently designing an 18V buck converter which draws from a 36V supply using the LM3150 IC Controller. I've attached the schematic of my design below.
18VSchematic.pdf Currently, while the buck works for low loads (~1A)…
Part Number: LM3150 Tool/software: Hey Everyone,
I'm using the LM3150 with 20V input to supply a 3.3V rail. These are my schematics:
VCC, VCCC, I can measure and are at 20V.
VCC5V95V I can measure and is at 5.95V.
C406, C407, C413, C414…
Part Number: LM3150 Hi,
We use the LM3150 for our power rail, we know the max. output current for LM3150 is 12A in datasheet,
we request the LM3150 for below spec.:Input voltage: 16-36V, output 5V/12A, and we find the output current can't reach the…
Part Number: LM3150 Tool/software: Hi team,
There is no limitation for slow / fast slew rate of EN input, right ?
EN have a hysteresis so I don't think there's no risk but I confirmed that just in case.
The customer asked us about the slew rate…
Part Number: LM3150 Tool/software: I'm working on a design with this part. Here are our inputs and schematic:
Vin = 12 V
Vout = 5.3 V
Iout = 6 A
It works relatively well, providing that C7 is not populated. When C7 is populated, Vout is…
