Answered

• LM3530: OVP pin has 0 V

  

  Mahdi Khalili

  Resolved

  Part Number: LM3530 Hi, I used the LM3530 for my display LED driver. I produced 8 pieces and 2 of them working fine. In other 6 PCB, I have the same voltage from SW pin to OVP. On normal PCB, the OVP pin voltage is 40V. But here I measure the same voltage…

  • Resolved

  • 11 months ago
  • Power management
  • Power management forum
Answered

• LM3530: HWEN - Minimum hold time, low, for a RESET

  

  Mark Pearson

  Resolved

  Part Number: LM3530 When resetting the IC - what is the minimum hold-time, low, to reset the device? i.e. I pull the HWEN pin LOW... but for how long? Also - once I pull the HWEN HIGH for normal operation - how long should I wait before starting I2C communications…

  • Resolved

  • over 1 year ago
  • Power management
  • Power management forum
Answered

• LM3530: Evaluation module of similar device

  

  Katsu Matsunaga

  Resolved

  Part Number: LM3530 Other Parts Discussed in Thread: LM3697 , LM3630A Hello, My customer would like to use LM3530 due to I2C control, but there is no EVM. Is there similar device to LM3530 which has EVM? Best regards, Katsu

  • Resolved

  • over 2 years ago
  • Power management
  • Power management forum
Answered

• LM3530: PWM pin treatment when PWM not use

  

  Katsu Matsunaga

  Resolved

  Part Number: LM3530 Hello, Please let me confirm pin treatment of PWM when PWM is not used. Can PWM pin be connected to GND? Best regards, Katsu

  • Resolved

  • over 2 years ago
  • Power management
  • Power management forum
Answered

• LM3530: Logic low threshold of HWEN

  

  K.Yaita

  Resolved

  Part Number: LM3530 Hi Team, According to the following specification, I believe HWEN pin should be applied down to 0V to reset wthout fault over the full operating ambient temperature range. Is my understanding correct? Best Regards, Yaita / Japan disty …

  • Resolved

  • over 5 years ago
  • Power management
  • Power management forum

• Lm3530,Lm3533,Lm355x.Lm3642,lp5562 , which one's driver initial procedure is compatible with Lm3435

  

  Eason Lee

  Other Parts Discussed in Thread: LM3435 If I want to write the lm3435 driver which chipset's driver sample code can I refer to design or there is other chipset I can use.

  • over 6 years ago
  • Power management
  • Power management forum

• Evaluation Board for the LM3530

  

  Hwang Beom

  Other Parts Discussed in Thread: LM3530 If I buy Evaluation Board for the LM3530, it includes USB Interface Board?

  • over 9 years ago
  • Power management
  • Power management forum

• LM3530SW-LINUX: Kernel start up error in Linux driver

  

  Ryotaro Fukui

  TI Thinks Resolved

  Part Number: LM3530SW-LINUX Other Parts Discussed in Thread: LM3530 , Hello team, My customer has a question about kernel start up error in Linux driver of the LM3530 into Linux4.14.98. My predecessor asked the same question in the link below, but it's…

  • over 2 years ago
  • Power management
  • Power management forum

• LM3559/LM3530 GUI

  

  PAN-M

  Other Parts Discussed in Thread: USB2ANY Hi These software couldn't work without the DELL PC. We were install this software to HP, Lenovo and so on, but not work. Is it correct? PAN-M

  • over 10 years ago
  • Power management
  • Power management forum

• LM3530SW-LINUX: Linux driver had an error when kernel start up

  

  Katsu Matsunaga

  Part Number: LM3530SW-LINUX Other Parts Discussed in Thread: LM3530 Hello, My customer is implementing a Linux driver of the LM3530 into Linux4.14.98. The device driver define in Kernel configuration, and describe the LM3530 in device tree as below. But…

  • over 2 years ago
  • Power management
  • Power management forum

Didn't find what you are looking for? Post a new question.