Part Number: LM36010 Hi,
In the datasheet, the Figure 35 is for writing. Does LM36010 support reading of the registers? Does it support re-start?
Thanks.
Part Number: LM36010 Hi team,
My customer is not clear with the name "IR mode".
Do the customer have to use the IR mode when lighting a IR LED?
Or is it only a mode that is recommended for IR LED usage?
In addition,
I guess that LM36010's…
Part Number: LM36010 Hi, team
Level trigger and edge trigger.
I test on EVM, in level trigger, LED turn off when STORBE go to low; In edge trigger, LED turn off when SOTRBE go to low and and after flash time out.
Is this the only difference level and…
Part Number: LM36010 Other Parts Discussed in Thread: LM3644 , LM3648 Hi team,
My customer wants to use 5V input to drive one channel 5 LEDs in series. The total voltage drop of the 5 LEDs in series is about 7~8V. So customer wants to find a boost structure…
Part Number: LM36010 From my customer-
I have designed a circuit for LCD backlight as below screenshot, and we have some problem.
We would like to control the current for LCD backlight from 0mA to 120mA, but we cannot increase the current over 55mA. …
Part Number: LM36010 Other Parts Discussed in Thread: LM36011 Hi E2E,
Good day!
Is it possible to implement an inductorless or simplified configuration using LM36010?
Looking forward to your response.
Best regards,
Franz
Part Number: LM36010 Other Parts Discussed in Thread: LM3643 Is there a way to disbable lm36010 during off state to save battery leakage power (uA)?
The LM3643 has a reset pin but lm36010 does not.
Part Number: LM36010 Dears,
I am using lm36010 as the camera flash or touch mode.
Is there any example code for this?
Could you provide its driver code for the reference? Or where can I find this code?
I am in a hurry situation and I don't have the EVM…
Part Number: LM36010 Is it possible to disable the Flash TIme Out (FTO) to allow a flash with a duration longer than 1600 ms (the Max value possible in Configuration Register 0x02)?
Part Number: LM36010 Hi there:
I'd like to help customer to check several question.
1. If the flash mode set-up: 1.5A for 1.6sec, -> the actual flash timing: 1sec and need to re-boot than LED back on
To read the Flag register: (0x05): 0x05 what…