Part Number: LM4040-N Tool/software: Hi team,
The datasheet was changed after PCN (20250326009.1), and the ESD CDM was increased from 200V to 500V.
I understand that RFAB products will be 500V, but will the ESD rating of SFAB and GFAB products before…
Part Number: LM4040-N Tool/software: Hi,
we are using the LM4040DIM3-5.0/NOPB voltage reference (5V version)
In the datasheet fig.5-4 is reported the Ir/Vr characteristic at Tj = 25°C
But what is the maximum reverse current variation, in the whole…
Part Number: LM4040-N-Q1 Other Parts Discussed in Thread: LM4040-N Tool/software: I'm currently using a zener diode to create a voltage approximately 2.5 to 3 volts below a positive rail, depending on the zener selected. The rail can vary from 11 to 16…
Part Number: LM4040-N-Q1 Tool/software: what is the operating temperature range for the LM4040A41IDBZR. On Mouser, it states -40 to 125 C, but the datasheet does not match that information. Also the datasheet says there is an extended temp range of …
Part Number: CDC6C-Q1 Tool/software: Hi team,
My customer asked what’s 25MHz CDC6Cx-Q1 orderable P/N for DS90UB971RHBTQ1? Thanks
Best Regards
Xiaowei Zhang
Hi Ian,
1. The current through LM4041 should be 208uA as you set this through the 24kOhm input bias resistor.
2. Adding a resistor at the output is fine as from an application standpoint this is seen as the load.
3. I am unsure as to why the current behaves…
Part Number: LM4040-N Tool/software: Hello everyone, what is the difference between the two types (LM4040CIM3-10.0 and LM4040CIM3X-10) ? I can't find any difference in the data sheet. Many thanks in advance.
