Part Number: LM4041-N-Q1 Other Parts Discussed in Thread: INA228 Tool/software: Hi Sir,
I want to design current source as below for LM4041. This schematic from LM4041 datasheet.
1) May i use the MMBT3906(package SOT23) to replace 2N2905 and 2N3964…
Part Number: LM4041-N-Q1 Other Parts Discussed in Thread: LM4041-N Tool/software: I'm trying to build a current source circuit (for small currents in 5uA range) and I found that I can use lm4041 adj with 2 pnp transistors to build it. (2n2905 & 2n3964…
Part Number: LM4041-N-Q1 Tool/software: Hi team, This is FAE Jayden, My customer is using LM4041QCEM3X-1.2NO. They need to evaluate the latch-up current of the device's VDD pin to guide their design. If you cannot provide this data, can you provide an…
Part Number: LM4041-N Other Parts Discussed in Thread: LM4051-N Hi,
I am considering a simple current source design (Iout smaller than 100mA from a 5V power supply) using either LM4041-ADJ or LM4051-ADJ, since their Vref is defined between the cathode…
Hi Andrew-san,
Sorry for my typo, is your answer same with in the case of room and whole temp and Vka "<" 2.5V ?
In the datasheet, this spec is defined in Vref<Vz<10V. The customer is concerning that in below 2.5V condition, change of reference voltage…
Part Number: LM4041-N I have been trying to use the LM4041_NA1P2_TRANS in PSpice and it seems like the device only regulates if the "annode" is connected directly to ground.
I found multiple forums that brought this issue up, but there was never any…
Part Number: LM4041-N-Q1 I am using LM4041QEEM3-1.2/NO regulator to get 1.2 volt output. But when checked it with no load condition it's giving me 1.4 Volt output an with 15 mA load it is giving me 0.8 Volt output. My Rs value is 47 ohm. Please suggest…
Part Number: LM4041-N Other Parts Discussed in Thread: TL431 , Tool/software: Hi team,
I have a question about the output voltage equation in Figure 8-3 and Equation (2) of the datasheet. It appears that the positions of R1 and R2 in the equation are…
Part Number: LM4041-N Dear Team,
Our customer is using LM4041CIM3X-ADJ/NOPB at mass production. however, it's old device.
they would like to replace new device in the future project if we have.
Best Regards,
Seijiro Matsuoka
