Part Number: LM43601-Q1
Hi Experts,
LM43601-Q1 is under evaluated on customer side. In order to meeting CISPR 25 Class 5, customer want to add a resistor between CBOOT and boot-strap capacitor. See the screenshot below:
In the datasheet and typical…
Part Number: LM43601
Tool/software: WEBENCH® Design Tools
Hi, Good day. Our customer noticed that the schematic design output for LM43601 and LM43601-Q1 is different. Although the BOM shows the same parts. They use the following parameters:
Vin…
Part Number: LM43601-Q1 Other Parts Discussed in Thread: LM43601 lm43601_12V_SCH.pdf
PFA the Schematics
Input Voltage => +12V
Output Voltage => -12V
Pls. note as of now we have not assembled J7 Common Mode Inductor.
At first POWER ON the output…
Other Parts Discussed in Thread: LM43602-Q1 , LM43601-Q1 Hello,
The Voutp-p simulation result of LM43602-Q1, LM43601-Q1 on Webench was about 100mV~120mV. Is this result correct? I think that this is error in webench. If yes, could you please correct…
Other Parts Discussed in Thread: LM43601-Q1 Hi
I have a question about LM43601-Q1.
In the datasheet LM43601-Q1 page 1,
About 600Mhz Emission level increases suddenly as shown above.
Do you know why did suddenly emission level increase in the…
Hello Alessio,
As you pointed out, the whole semiconductor industry is impacted right now so certain chips are hard to come by.
I don't have any information regarding future availability of the LMR50410/LMR14010, but the following devices have availability…
Other Parts Discussed in Thread: LM43601 , TPS1H100B-Q1 Hi,
I installed PSpice for TI yesterday then used it to capture and simulate a design after which it was closed. However, when I re-opened the un-altered design today the simulator reported an…
Other Parts Discussed in Thread: LM53601-Q1 , LM43601 Hi~ All..
Customer want to use spread spectrum function, so we suggested LM53601-Q1 in automotive application.
But in datasheet, LM53601-Q1 only can support down to 3.3V, but there is description…
