Hi Parvathy,
Sorry for reply late.
LM4510 is suitable for the application.
please be careful at 3Vin 12Voout 200mA it almost reaches the minimum current limit 1A.
It is recommended to leave some margin.
Best Regards
Fergus
Part Number: LM4510 We have a design using the LM4510 part to boost a single cell LiPo battery to 12V to power an OLED display. We have had 2 cases where the IC has worked normally, then after a few hours of intermittent use, the IC fails to regulate…
Part Number: LM4510 Other Parts Discussed in Thread: TINA-TI , Tool/software: TINA-TI or Spice Models Good morning,
in Tool and Software section of LM4510 chip there are not Model's.
I'm interested to "Unencrypted PSpice Models" or WEBENCH design tool…
Part Number: LM4510 Dear all,
I have few questions about operating LM4510.
1.Can the "true shutdown isolation" function turn on/off the output voltage between 0V and Vout?
2.What is the maximum frequency of turning on/off the device? Can I use…
Other Parts Discussed in Thread: LM4510 Hey,
i want to use an LM4510 boost converter. Spec: VIN: 4.8V nom, VOUT 13V (OLED) Iout = ~50mA
When i'm calculating I_LAVE with Eq. 3 i get about 170mA. Ripple current should be about 30% of I_LAVE, so lets say…
Other Parts Discussed in Thread: LM4510 The LM4510 datasheet lists shutdown current in small fractions of microamps. Typically, chips don't have parameters with values in the nanoamp range because it's too difficult to measure such small currents quickly…