Part Number: LM50 Hello team,
How to distinguish legacy and new device for LM50BIM3X/NOPB?
In datasheet, "LM50BIM3X/NOPB (Legacy chip) operates from –25°C to 100°C while LM50BIM3X/NOPB (New chip) operates from –40°C to 125°C." is described.
Best…
Part Number: LM35 Other Parts Discussed in Thread: LM50 ,
Tool/software:
My company currently uses the LM50 component to evaluate and report a system temperature data stream. The absolute accuracy is not of incredible concern for me, however we use…
Part Number: LM50 In our measurement, we found that the voltage was too high at normal temperature. According to the specification, it was +/-3, but it was actually exceeded. Please help to confirm
Part Number: LM50 Hi team,
My customer need assistance.
we are using LM50CIM3 in our design. There is junction to ambient thermal resistance(RθJA) mentioned twice in the datasheet: www.ti.com/.../lm50.pdf
(1) In section 6.4 RθJA mentioned as 291…
Part Number: LM50 Other Parts Discussed in Thread: TMP235 Hi experts,
I want to recommand the analog temperature sensors to replace LM50CIM3X/NOPB because of supply issue.
Could you help me identify the device which have the same function and pin…
Part Number: LM50-Q1 Hello,
I'm Taewook Kim in Halla mechatronics.
I have a question about LM50-q1.
I have seen a Supply current in datasheet.
Supply current is around 90uA@5V, 25deg . But Quiescent current is also same value in 25deg.
Is Supply…
Part Number: TMP235 Other Parts Discussed in Thread: LM50 , , LM50-Q1 , Hi,
Is it true that the only difference between TMP235 and LM50 is the voltage supply range?
The output voltage vs. temperature equation seems to be the same, and the accuracy…
Part Number: LM50-Q1 Other Parts Discussed in Thread: TMP235-Q1 Team,
Can you please help address this customer question:
From datasheet LM50-Q1 maximum output voltage is 1.75V@125℃. But Operating temperature is below 150℃.
What is output voltage…
Checking the output of the 5V regulator didn't reveal any transients but did show that it had some high frequency noise which was carrying through to the output of the LM50. What I was measuring then was the average of this noise. I added 0.1 uF to the…
