Other Parts Discussed in Thread: LM5005 Hi all I have two questions about LM5005. 1.Datasheet P.16 R1,R2,C12 I see the following text. "when using an external set-point divider it may be necessary to clamp the SD pin at high input voltage conditions.…
Part Number: LM5005 Hi Team, Could you tell me the value of internal current sense resistor? My customer also wants to know variability of the resistor. Best Regards, Yaita / Japan disty
Hello David,
we isolated the DAP from the -19V and it worked.
I don't really know why it worked on my evaluation board where the exposed pad was connected to ground.
I assume that it is a combination of the DAP connected to ground and layout, why…
Part Number: LM5005 Hi team, I uses the webench of LM5005 to refer the recommended circuit. The tool showed me the following ciecuit. Simulation parameter Vin=12V to 48V Iout=5V Iout=2A(max) The tool showed Cin=3.3uF. However, in the data sheet, the recommended…
Part Number: LM5005 In operational mode,when the load is open,the test of input current is about 5 mA.
Is it OK?
What is the current when the load is open?
test enviroment: input 12V, output 5V, load open.
Part Number: LM5005 Hi all Would you mind if we ask LM5005? We simulated the circuit to calculate phase margin using Figure.17 on the datasheet P17. We choiced the Cout=172uF with ESR=0.035ohm. The phase margin was over 60 degree.(it was OK.) In your…
Other Parts Discussed in Thread: LM5005 Hi all I see the referensc circuit (Figure 1) of LM5005. You selected the R7 resistance is 10Ω/1W. However my customer can not prepare same spec resistance. So my customer would like to use R7 10Ω / 1/4W spec resistance…
Hi Kato,
Please try creating the WEBENCH design from the search panel for the LM5005 while we are fixing the link from the product folder.
http://www.ti.com/sitesearch/docs/universalsearch.tsp?searchTerm=LM5005#linkId=1&src=top
Regards,
Ger…
