Part Number: LM5010 Hi
I've been tasked to design a 48-24VDC power supply using the LM5010 step-down switching converter. I'm a student beginning to learn circuit design and as of yet don't know off the top of my head the usual expected values of support…
Part Number: LM5010 Tool/software: Hi!
I made a 12V step down design with LM5010. Converter is quite tricky because it is referenced to -48V. Converter feed two fans with around 0.5A total courrent consumption. Sometimes Converter simply fail.
What…
Part Number: LM5010
Tool/software:
Currently using 14 pin LM5010AMH IC in SMPS for switch system in battery management system.
Currently seeing external noise / transients breakover an interlock coil and onto an internal 12V supply line.
Noise…
Part Number: LM5010 Tool/software: Current using 14 pin LM5010AMH IC in SMPS for switch system in battery management system.
Currently seeing external noise / transients breakover an interlock coil and onto an internal 12V supply line.
Noise results…
Part Number: LM5010 Other Parts Discussed in Thread: TPSM365R6 Hey team,
can you please help:
We continue to use the LM5010MH/NOPB HTSSOP14 regulator in a redesign.
If this is short-circuited at the output p24V to GND and the short-circuit is…
Part Number: LM5010 Hi,
The test inductance in the LM5010SD/NOPB power supply circuit has been "howling", resulting in our audio acquisition equipment can recover the problem of inductance "howling".
The usage requirement is Vin 12-48V, Vout 5V…
Part Number: LM5010 Hi,
We are trying to achieve 10V/1A using LM5010 with Input voltage range of 12V-70V.
At 12V-24V, its gives 9.4V at 1A.
And above that, like at 36V, 48V. It drops till 9.4V at 0.5A and 2V at 1A.
Following is the waveform…
Hi Daniel,
Can you please review this Layout?
And can you tell me why there are gaps(vertical line and arc around via) on bottom ground plane of LM5010 EVM on page 6:
Regards,
Anurag
Part Number: LM5010 I have an application where I need to diode-OR a power supply from two different sources. Is it ok to apply power to the output of a LM5010 regulator when its input is unpowered or do I need to insert a series diode in the output?
Part Number: LM5010 Dear Team,
I'm currently designing a new DC-DC converter to be used in a BLDC Drive.
Since I'm new to designing, I'm doubtful to proceed with this Schematic. I've got different values in WEBENCH and LM5010 calculator Please verify…
