Part Number: LM5051
Hi,
This is a continuation of "Related Questions".
I'm considering using the LM5051 that was previously introduced to me. It is expected that the Vds of External-FET will be regulated to 45mV(Typ). In that case, the external…
Part Number: LM5051 Hello guys,
This is a similar question with the following URL. https://e2e.ti.com/support/power-management-group/power-management/f/power-management-forum/1252552/lm5050-1-how-to-buffer-lm5050-gate-pin-to-driver-fet-gate-which-has-large…
Part Number: LM5051 Other Parts Discussed in Thread: TPS40075 , LM27403 ,
Hi Team,
Our customer is looking for a DC/DC converter with Vin = 15V and Vout = - 12V, Iout = 2A and can be connected in parallel to the same DC/DC converter to increase the output…
Hi Neo,
In case you are considering using LM5050-1, please refer to the e22 FAQ below on how to resolve the leakage issue (similar to the one seen in LM5051).
LM5050-1: LM5050-1 Leakage Current
https://e2e.ti.com/support/power-management/f/power-management…
Part Number: LM5051 Hi Expert,
My customer want to see if TI have any similar solution to replace the IR5001S.
They want to find the one part can put to used in both of high side and low side.
Please share your comment for me .Thanks!
Eddie
Part Number: LM5051 Hi team,
Are there any reverse current protections devices or solutions that can support 150Vin&Vout, 0.5A load?
Regards,
Noriyuki Takahashi
Part Number: LM5051 I confirming LM5051 for High side (positive) OR-ing because of LM5050 and the other are not availability.
Below E2E thread is described possible to use positive supply, but datasheet page-14 is described LM5051 can not configure positive…
Part Number: LM5051 Hi Support team
The minimum input voltage will be 19V
According to the actual measurement, compared with the input voltage of 36V, the Vgs voltage of the FET is relatively low, but it is still higher than the MOSFET Vth specifica…
Part Number: LM5051 Hi team,
Could you tell me θJA of LM5051?
Unfortunately, there is no description in the datasheet about the parameter. My customer need to input device char info to their internal parts DB prior to use it in the system.
Regards…