Part Number: LM5066I Hi sir,
Can LM5066I address be modified?
For LM5066I I2C, is LM5066I slave only, or it can be master?
Could you please help clarify if LM5066I can only be read via the GUI or BIOS and the address data cannot be modified?
Thanks…
Part Number: LM5066I Other Parts Discussed in Thread: LM5066 Hi sir,
Customer is wondering if LM5066I can do parallel design, like below.
Pls provide the reference design, thanks a lot!
Part Number: LM5066I Hi Ti Experts,
We want to disable OCP function and then change from R-shunt part to short through, have any side any effect? output short protection is still exist? Thanks.
Part Number: LM5066I Hello,
This chip has all the features for our application but exceeds our power budget. The system will be nominally 58V. At 5.6mA to 7mA IN-EN current, this is 325mW to 400mW to effectively just keep a switch closed (yes, I know…
Part Number: LM5066I hi sir
the LM5066I Be used for Power protect,
during the power off , the Vg spitch again as the photo,
damage the Mos, Did you have any idea? thanks
blue:Vd, Purple:Vs
yellow:Vg
blue:Vd, Purple:Vs
yellow:Vg
green…
Part Number: LM5066I
Hello, during operation, the gate voltage may become equal to the VIN voltage due to a large capacitive load at the rear stage, causing the external MOSFET to fail to turn on properly.
Under normal operation, the gate voltage…
Part Number: LM5066I Hello,
The customer uses LM5066I components. It may be due to a large capacitive load in the rear stage, causing the gate voltage and VIN voltage to be the same. Causing the external MOS to fail to open. During normal use, the gate…
Part Number: LM5066I Other Parts Discussed in Thread: LM5069 , Hi, For the LM5066I and LM5069, the design calculations are very similar. However, for the LM5069, the calculation shown in Equation 60 of the LM5066I datasheet does not appear to be performed…
Part Number: LM5066I I design a 48V hot swap circuit board, refer to "tidmd42a_2kw". When I want to bring up, supply Vin 48V, and the output is around 5.6V only. | I checked some points below Vin = 48V Timer = at first reach around 4V then down to 0V…
