Part Number: LM5066I Other Parts Discussed in Thread: TPS25985 , LM5066 Hi Team,
In the TI .com, LM5066I mention it can support up to 500 A current limit (max) (A).
Customer is wondering is it possible ? Does TI have a real case that support up to 500A…
Part Number: LM5066I Hi Team，
A Schottky diode is recommend at the Vout to limit the negative voltage, and protect the IC. Could you pls comments on the how to select the right diode? Thanks！
Regards, Hailiang
Part Number: LM5066I
Hi TI expert,
I have issue when using LM5066I as power monitor and management in project.
The SMBA pin output low randomly after board is powered up, and I tried to read the STATUS_BYTE register(0X78h) which has default value 01h…
Part Number: LM5066I Because this IC will start to control gate voltage if detecting power limit or current limit to limit current, I have set IC current limit much more higher we are using and build external current measurement for protections. When…
Part Number: LM5066I Other Parts Discussed in Thread: LM5066 when a few LM5066i connect to the same I2C, each LM5066i has a VDD output, I2C pull up resistors connect to VDD.
how to deal with those VDDs?
can all these VDDs connect together ( parallel)…
Part Number: LM5066I Other Parts Discussed in Thread: TPS2663 , LM74910-Q1
Hi, Support Team
About LM5066I have reverse current(Voltage) blocking functionality?
Should we add back to back FET circuit?
if any suggestion, Please advise me.
Thanks,
Best regards…
Part Number: LM5066I Is there any way to change the fault discharge current? It looks like it is fixed at 2.5 uA. I have an application where the current limit is programmed to 20 A and the fault timer to 12 ms. The average current is typically around…
Part Number: LM5066I Other Parts Discussed in Thread: LM5066 Hello,
We are looking to use an isolator in a design that we are looking to be powered by the LM5066I 4.85V VDD pin. We see that the VDD pin was intended only for passives and not for an IC…
Part Number: LM5066I Hi Team,
SMC is looking for a quick answer :
"Could you help to investigate the question and feedback ASAP since we have design deadline? Thanks a lot.
If we choose No retry, will the Gete pin control be the same? If not, what…
Part Number: LM5066I Hi
I have some question about CL setting and Fault time behavior.
Q1. is it correct?
PIn setting: there are 2 CB value (1.94x or 3.87x current limit) ==> Base on CL pin connect to VDD or GND or leave floating
SMBUS setting: there…
