Part Number: LM5085-Q1 Other Parts Discussed in Thread: LM5085 , LM5175 Tool/software: I want to use the LM5085 in the to genrate the 7.5V, 5A.
But VIN is 4.5V -36V, so I have the question, when the VIN is less than the VOUT, maybe VIN is 4.5V to 7.5V. …
Hello, The ADJ pin is 11mm far from the MOSFET. And, the ISEN is connected to source of the MOSFET, and the gate comes from the LM5085 IC, then from drain to the output connections is this correct ? I am bit confused now, the ADJ pin should be connected…
Part Number: LM5085 Other Parts Discussed in Thread: LM5148 , LM5149 Tool/software: Hello, I want to design the LM5085 to give 10A at the output, can I know the component ratings for the diode, inductor, and MOSFET mainly?
Can we use multiple 0805, 0603…
Hello Aakash
It is not allowed to disclose the internal structure of the device, but you can find what you want in the Absolute Maximum Rating table.
In general, the Absolute Maximum rating is defined by the ESD cell rating. Please find the 10V Abs Max…
Part Number: LM5085 Tool/software: Hi TI team.
In a new design we are using the LM5085. VIN = 4.95V-42V, VOUT=4.55V at 0.95A.
VSW is OK at NO Load/light load and high load. Ripple it seems OK at light load but I am a little worried about the ripple at…
Part Number: LM5085-Q1 Other Parts Discussed in Thread: LM5085 , LM5149 , LM5148 Tool/software: Hello, I want to design the LM5085 to give 5V and 10A at the output, the input would be from 10V to 60V. I need two of the same circuits on the same board of…
Part Number: LM5085 Other Parts Discussed in Thread: LM25148 , LM5148 , LM5146
Hi, I need help in choosing a buck converter IC for the following design requirements. Input = 10 to 60V output = 8.4, 12.4,16.8V respectively(using FB resistors probably) Output…
Part Number: LM5148 Other Parts Discussed in Thread: LM5085 , LM5146 , LM5143 Tool/software: Hi,
Can you please help review the attached schematic below and see if you notice any issues.
There are two buck converters, the one based off of LM5148 is to…
