Part Number: LM5101 Other Parts Discussed in Thread: TINA-TI , , SM74104 , , PSPICE-FOR-TI Tool/software: I am unable to find LM510A model among the libraries given in TINA Spice under Spice Macros.
I am using this part to drive the NMOS output switches…
Part Number: LM5101 Hi Sir,
Could you please suggest any TI part equivalent to LM5101 High Voltage High Side and Low Side Gate Driver with Operation temperature range of -55C to +125C.
Regards,
Nesh
Part Number: LM5101 Other Parts Discussed in Thread: , UCC27282 Hi TI EE：
could you pls let me know if the simulation model of LM5101 on your company's website can be simulated in LTspice or simplis? it seems I can't open the model with these two software…
Part Number: LM5101 Other Parts Discussed in Thread: UCC27282 Dear Sir,
I wanted to simulate LM5101, but I am not able to find any spice model in the TI website.
Could you please share Pspice model of LM5101.
Thanks and Regards,
Nesh
Part Number: SM74104 Other Parts Discussed in Thread: LMG1020 , LM5101 , , UCC27282 , LMG1205 The ~20ns propagation delay times of these parts suggest that they could be operated at frequencies up to ~50MHz. If not, what is the upper frequency limit and…
Part Number: LM5104 Other Parts Discussed in Thread: LM5101 hi,
My customer is developing a module, and they found the Negative voltage on drive’s input and output pin were higher than -0.3V, is there any risks for this application?
Here are the Schematic…
Other Parts Discussed in Thread: LM5101 Hi eveybody,
I'm trying to drive a BLDC motor and i made a driver for this. I used LM5101 for drive to mosfets. Initially driver worked but later LM5101 burned twice. I dont know why it burned. My pwm frequency…
Other Parts Discussed in Thread: LM5101 I would like to know what is the minimum frequency at which I can run the LM5101 high side driver? Is there a built in chopper on the bootstrap circuit to refresh the high side drive voltage to overcome gate leakage…
Other Parts Discussed in Thread: LM5101 Hello,
I have a very simple H-bridge with one LM5101 hugh/low side driver for each leg. The bridge is driven at frequencies below 1Hz. Therefore the upper gate driver is suppliet from a separate 12V DC/DC converter…
Other Parts Discussed in Thread: LM5101
Hi all I'm trying to simulate a circuit including LM5101 which has an encrypted spice model. While I read in some forums that Orcad 15.7 and newer can easily handle encrypted models, I still have problem with…
