Part Number: LM5111 Hi team,
I will follow up this issue as Lin has asked before. Please see the below link for details:
https://e2e.ti.com/support/power-management/f/196/t/874169?tisearch=e2e-sitesearch&keymatch=LM5111
Now I asked customer to test…
Part Number: LM5111 Other Parts Discussed in Thread: LM5112 Hi,
My customer use LM5111 as ultrasonic proble driver, but found several boards get fire and damaged as below first picture, do you have met similar cases before?
Schematic and PCB are attached…
Part Number: LM5111 Other Parts Discussed in Thread: UCC27624 Customer is looking to replace existing gate driver with LM5111-4, however existing device has Enables on pins 1 and 8. These are pulled High on existing board.
If pins and 8 are true No…
Part Number: LM5111 Dear Expert,
Thank you for your support everyday.
My customer has a question about reflow condition of LM5111.
Are there restrictions on temperature, time, number of times at reflow?
Best,Regars.
Fukazawa
Part Number: LM5111 Dear Specialists,
My customer is considering LM5111 and has a question.
I would be grateful if you could advise.
---
I'd like to know the Absolute Maximum Rating of OUT A and OUT B.
The datasheet is not described.
Are these…
Hello,
Thank you for your reply. When you say "It is specifically mentioned many times that it should be tied to ground only." - do you refer to the spice model or to the LM5111-1 itself? I do not intent to use it in a classical High-Side or Low-Side…
Other Parts Discussed in Thread: LM5111 Hey Team,
The specification says that we can sink 5A, and that was tested for a 200nS period. We have a matrix circuit that is being driven by a MOSFET that’s driven by the LM5111. The MOSFET is driving a 4V capacitive…
Part Number: UCC27324 Other Parts Discussed in Thread: LM5111 , , UCC27624 hi team,
my customer is using UCC27324 as a second source of LM5111, but the layout of LM5111 has been fixed with NC pins floating.
so can our UCC27324 NC pins be left floating…
Other Parts Discussed in Thread: UCC27284 , LM5111 When selecting a MOSFET, there are two different types that can be considered for either a low-side or high-side switch. There are NMOS and PMOS MOSFETs to select from.
With an NMOS FET the source and…
