Part Number: LM5112 Hello,
May I to know what this step works for？Is it good for solder reflow soldering?
Looking forward to your reply,thanks.
best regards!
Miss Yang
Nov.10.2022
Part Number: LM5112-Q1 Hello,
On a DCDC converter we use LM5112Q1SD for drive the MOSFET bridge and it is work perfecly.
Before assembling the product, we test each board with flying prob and we measure the output impedance of the driver (OUT pin…
Other Parts Discussed in Thread: LM5112 , UCC21225A Hello,
I wonder if TI provides IBIS model of gate drivers, LM5112/UCC21225A/27201/27282/27324/27524A. It doesn't look it's provided if the device doesn't have PMbus/I2C communication functionality…
Dear Jeff,
no i just connect the 5112 and the 1020 "just" to give an idea where i neet to place the switching mos (or high side or low side), but good to know that the 5112 is a low side.
Unfortunatlly this project demand to pilot the led in both…
Part Number: LM5112-Q1 Hi
in case a voltage applied on the input pin trough 20K pull up resistor before VDD is supplied to the IC.
Can it cause a latch-up? the current is very low ~0.15uA
or any other issue with the IC?
Part Number: LM5112-Q1 Other Parts Discussed in Thread: LM5112 , TINA-TI hi
I am trying to use LM5112 spice model in Keysight ADS but it sais it has a syntax error.
I read in one of the threads here that it is due to bad translation off switch models…
Part Number: LM5112 I am working on a design using the LM5112 on a dual-supply (+6 and -8V) application. I would like to connect the IN_REF pin to ground to allow for simple TTL control. The recommended operating conditions specify that VCC to IN_REF…
Part Number: LM5112 Hello,
I have the following doubt:
Is it possible to use the LM5112 as a gate driver for a synchronous buck converter using a microcontroller? If it is possible, how should I make the connections between power, microcontroller…
Part Number: LM5112
Dear Sir/madam,
We have bought LM5112MY/NOPB which is GaN gate driver from Mouser and have tried to layout.
However we could not find mechanical support to layout the device.
Could we get the mechanical data to layout the device…
