Part Number: TPS54362-HT Other Parts Discussed in Thread: LM5116-HT , , OPA2333-HT Tool/software: Hi there,
I am looking for IBIS models of TPS54362-HT and LM5116-HT parts. Where can I find it?
Best regards.
Part Number: LM5116-HT Other Parts Discussed in Thread: LM5116 Tool/software: Hi there once again,
I was simulating the LM5116 circuit. I have a question related with the topic I opened few months ago: https://e2e.ti.com/support/tools/simulation-hardware…
Part Number: LM5116-HT Other Parts Discussed in Thread: LM5116 , We have been working on a power supply design using the LM5116. This is a high temperature design so we are going to use the HT part. To save some cost (avoid destroying $300 parts), we…
Part Number: LM5116-HT Other Parts Discussed in Thread: LM5116 Tool/software: Hi there,
I am designing a power stage based on the LM5116JHD (LM5116-HT). Due to the high temperature ambient conditions (up to 175ºC ambient temperature), it is not possible…
Part Number: LM5116-HT Tool/software: Hi there,
I am looking for thermal pad/via information for LM5116-HT.
I cannot find useful information in the datasheet about that topic.
I am designing a PCB which will work in high ambient temperature conditions…
Part Number: LM5116-HT Other Parts Discussed in Thread: LM5116 Tool/software: Hello,
I am trying to simulate with LTSpice the circuit that I would use. The main parameters are: Vin (min) = 18V, Vin (typ) = 28V, Vin (max) 50V, Vout = 12V, Iout = 7A…
Part Number: LM5116-HT Other Parts Discussed in Thread: LM5116 Tool/software: I have a high temperature issue with a LM5116 regulator. The design is for a 24V 4A power supply with an input voltage range from 30V to 70V.
The regulator works well until…
Part Number: LM5116-HT The data sheet for the LM5116-HT seems to have a bit of a discrepancy. Under Absolute maximum ratings it say that Vin has a max of 80V, but on page 12 it says "The input pin (VIN) can be connected directly to an input voltage source…
Part Number: LM5116-HT I have a 60V power supply using the LM5116HJD. I'm currently using diode emulation mode, but I'm wondering if its better not too? Efficiency at lower power is not a big concern.
I am using a sense resistor (not trying to use Rds…
Part Number: LM5116-HT Other Parts Discussed in Thread: LM5116 we used LM5116 Inverting buck boost in our design as per the TI WEBENCH reference. we are facing issue with that converter, it is not working as per expected.
input voltage : 28V
output…
