Part Number: LM5116EVAL Other Parts Discussed in Thread: LM5116 Hi, Good day.
Our customer would like to have the design files of this Eval board.
If possible in Altium tool files. Thank you. Regards, Cedrick
Part Number: LM5116EVAL Other Parts Discussed in Thread: LM5116 Dear E2E Forum,
I need to use LM5116EVAL/NOPB
I need minor modification as per my requirement given below:
I/p on this card supports upto 100VDC , my requirement for I/p is 45V-95V DC. …
Part Number: LM5116EVAL Other Parts Discussed in Thread: LM5116 Hello,
We are using an LM5116 in a 48v to 28v (2A max) SMPS design. Under certain load conditions (~150-300mA) the circuit seems to become unstable and can often cause the low-side FET to…
Part Number: LM5116EVAL Other Parts Discussed in Thread: TINA-TI , LM5116 Tool/software: TINA-TI or Spice Models Hello,
I tried simulating the LM5116 example that is available in the TINA Spice software. Though it is been provided that the board has been…
Hello Syed
1. Required Rramp is 121k, Cramp is 1nF. Please change E9 to change inductance (L)
2. Please refer https://www.ti.com/tool/LM5116-12EVAL and https://www.ti.com/tool/LM5116EVAL
4.5 net-tie is optional, it is recommended to separate analog ground…
David, when I pressed "reply" button previously (question referred to the possibility that math estimate is not even possible), then I saw your post with link to calculating efficiency that makes my previous question irrelevant. Calculations provided…
Hi Manimaran,
Can you share more detail on the design? If your feedback resistor divider is set up correctly, and you are not getting the 5V output, you should see some strange behaviour on the SW node. It could be the circuit is not configured properly…