Part Number: LM5145-Q1 Dear Team,
First of all, thanks for the continuous support.
Sir this is the circuit I made, and we have prepared layout as per the guidelines and PCB fabrication and assembly completed. I have 3 similar circuits on my assembled…
Part Number: LM5145-Q1 Hello sir,
We used LM5145-Q1 for first level power supply design.
Vbat=12V (typical), VOUT=3.3V, IOUT=14.4A, FSW=250KHz, how to calculation IC LM5145-Q1 power dissipation for thermal simulation?
I used WEBENCH to simulate and there…
Part Number: LM5145-Q1 Other Parts Discussed in Thread: LM5146 Tool/software: I have design buck converter (LM5145-Q1), input voltage is 54V and output voltage is vary from 1V to 10V by adjusting feedback resistor at max.8A load. I am getting expected…
Part Number: LM5145-Q1 Other Parts Discussed in Thread: LM5145 Good evening!
This question is regarding load test of the LM5145 Buck regulator IC.
I have designed my circuit for 24V output voltage and 30A output current. for the load purpose i have connected…
Part Number: LM5145-Q1 Other Parts Discussed in Thread: CSD18563Q5A Tool/software: I have designed my circuit as shown below. The circuit works perfectly well in simulation but when testing the designed board, I seem to have an issue where the soft start…
Part Number: LM5145-Q1 Other Parts Discussed in Thread: LM5145 Tool/software: Hello TI experts,
I want to check what will happen if pin BST shorting to pin SW during normal working?
Thanks a lot.
Part Number: LM5145-Q1
The above graph we are getting in the oscilloscope for the switching of High side and Low side MOSFET of the converter design we given below.
There is so much noise coming in the Switching signal of the GATE driver. To decrease…
Part Number: LM5145-Q1 Other Parts Discussed in Thread: LM5145 I need to know the maximum output current capability of the IC LM5145 75-V Synchronous Buck DC/DC Controller with Wide Duty Cycle Range. can you please share those details of the IC LM5145 …
Part Number: LM5145-Q1 Other Parts Discussed in Thread: LM5145 Dear TI Team,
We required buck converter schematic for 24V 20Amp ratings. Please recommending us to find correct schematic and buck converter chip for our application.
We was planned use LM5145…
