Part Number: LM62435-Q1 Tool/software: Dear Texas Instrument,
I have a question regarding the pin PGOOD and its respective resistor (Rpg). Data sheet defines the resistor value as follows:
Typical application section shows the EN pin being connected…
Part Number: LM62435-Q1 Other Parts Discussed in Thread: LM25148 Hello,
I want to supply the LM62435's BIAS pin from an external 5 V regulator. However, sometimes this external regulator will be on when the LM62435's VIN is off; i.e VIN=0 V and BIAS=5V…
Part Number: LM62435-Q1 Hi, Experts:
I am planning using LM62435-Q1 in my system, and I have a question about the light load operation.
in your spec, there are Diode emulation and frequency reduction , I understand Diode emulation , but I am nott familar…
Part Number: LM62435-Q1 Is there any plan to release a transient model for LM62435-Q1? I see LM62440 is recommended since they are equivalent besides a min value on Il-ls but wanted to check.
Another question - does LM62440 only use typical characteristics…
Part Number: LM62435-Q1 Due to shortages I would like to specify the B or C variant of the 62435 and a single top side divider resistor to increase the output voltage. Since the fixed version FB pin is a must connect there should be an internal divider…
Part Number: LM62435-Q1 Hi Team,
Can you please recommend output capacitance requirements for VOUT = 9V and max load step is 2.5A? Table 6 in the datasheet only lists recommendations for 3.3V out and 5V out.
Thank you!
Jared
Part Number: LM62435-Q1 Hey Team,
The LM62435's Pspice simulation model is not available on the product page of TI.com
Looking forward for your support.
Thanks,
Akash
Part Number: LM62435-Q1 Hi,
I am planning to use "LM62435-Q1" for converting 24VDC to 5V, 3A.
5V is supplied to external components (Load cell) using a connector, in industrial environment.
5V@3A supply should be stable as this is the important…