Part Number: LM63625-Q1 Dear E2E TI community,
LM63625-Q1: Do we have Fsw as 2.1MHz for HTSSOP package as well, by just direct connecting RT pin to AGND? Or is this available only with WSON Package?
What I understood from below data sheet snap that…
Part Number: LM63625-Q1 Hi team,
The datasheet mentions the following behaver in "8.4.2.1 Sync/FPWM Operation". When a valid clock signal is present on the SYNC/MODE input, the switching frequency is locked to the external clock.
How does the device…
Part Number: LM63625-Q1 Hi team,
Could you please help to share some efficiency test data of LM63625-Q1 under below condition? Thanks.
Vin: 8.5V, 12V, 16V
Vout: 3.3V
Load current: 100-150uA
Frequency: 2.1MHz
Arie
Part Number: LM63625-Q1 Dear team
In the case, the device will work in SYNC mode with external clock input.
1. Dose the external clock have spec?
2. Is there a specification for the waveform of this external clock input?
Many thanks
Denny
Part Number: LM63625-Q1 Other Parts Discussed in Thread: LM63635-Q1 , Hi Expert,
Our customer design LM63625-Q1 and schematic but they want to use LM63635-q1 with p2p upgrade without any hardware change. Do you have any recommendation for below design…
Part Number: LM63625-Q1 Hi Expert,
Can you help to share the formula or calculation tool to calculate the IC power dissipation for LM636X5-Q1 family? Thanks.
Arie
Part Number: LM63625-Q1 Hi team,
Could you advice if /RESER pin goes Low after tdg time when it hits over current (Ios)?
When load current exceed Isc, it limits the current to 20% of Iomax after tdg time and then /RESET goes Low?
Could you advice…
Part Number: LM63625-Q1 Hi,
I need Calculate Minimum Inductor Value required for my Design using LM63625DQPWPRQ1 Regulator.
Section 9.2.2.3 Inductor selection in LM63625-Q1 Datasheet
Here, What is the Unit of M?
Part Number: LM63625-Q1 Hello team,
I have two questions for LM63625-Q1 below. Could you please answer below?
1.
I would like LM63625-Q1 to operate with adjustable Vout.
Table 8-2 says floating the VSEL pin will set the device for adjustable Vout…
Part Number: LM63625-Q1 Hi,
Good Day. What is the Switch Diode drop voltage required for calculate Switching Loss of MOSFET and Maximum Inductor Peak Current Limit of LM63625-Q1? Thank you very much.
Best Regards,
Ray Vincent
