Search tips
Showing 6 results View by: Thread Post Sort by

  • LM74610-SQEVM: Add depletion mode MOSFET for higher withstand voltage and battery backfill

    Part Number: LM74610-SQEVM Tool/software: Hi Ti experts, My customer wants to use LM74610 in 4-foot dog for battery backfill. Since withstand voltage between cathode and anode is 42V. So customer wants to add depletion mode MOSFET for higher withstand…

  • LM74610-SQEVM: LM74610 can not turn NMOS FET

    Part Number: LM74610-SQEVM Other Parts Discussed in Thread: LM74610-Q1 I only change NMOS FET vs LM74610 reference schematic, test results for LM74610 below: Pin 1: 12V; Pin 2 & Pin 6: 11.7V Pin 4: 12V; Pin 7: 15V; Pin 8:11.4V You can see…

  • LM74610-SQEVM: Understanding Schematics For this Evaluation Board

    TI Thinks Resolved
    Part Number: LM74610-SQEVM Other Parts Discussed in Thread: LM74610-Q1 I am planning on using LM74610 for reverse polarity protection and bought this evaluation board. I am seeing in the schematics and data sheet for this for C6 and C7 capacitor as a…
    • Answered

  • LM74610-SQEVM: LM74610-SQEVM for 24V <-> GND (reverse polarity protection)

    Resolved
    Part Number: LM74610-SQEVM Other Parts Discussed in Thread: LM74610-Q1 , LM74700-Q1 , LM74700EVM Hello, what would be necessary to have a reverse polarity protection of 24V for the LM74610-SQEVM? I have this device here but it is only ratet for +12V to…
    • Resolved
    • Answered

  • LM74610-SQEVM: If a N-channel FET would be used, will current flow from S to D be Ok?

    Resolved
    Part Number: LM74610-SQEVM Other Parts Discussed in Thread: LM74610-Q1 If I understand correctly, when using a n-channel FET in the power line side (not in return path), the FET will be switched on by a charge pump driving the gate. If the gate would…
    • Resolved

  • RE: LM74610-Q1: Timing of Vcap does not match the expected value

    Hi, We purchased the evaluation module LM74610-SQEVM and ran the same tests: http://www.ti.com/tool/LM74610-SQEVM The same behaviour that we had in our PCB could be seen in the evaluation module as well. Best regards, Inigo

Didn't find what you are looking for? Post a new question.